The 12 h 25 min cycle
Why the tides come 50 minutes later every day, the one number the clock needs, and the honest truth about how well an average fits a real coast.
Open it in the simulatorA wall clock for the sea: why tides come every 12 h 25 min, a servo hand from high to low, a DS3231 that keeps the time, and one high tide from your port’s table, with an honest look at why it is never for navigation.
0 of 6 done
6 lessons in 3 chapters, about 4 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Why the tides come 50 minutes later every day, the one number the clock needs, and the honest truth about how well an average fits a real coast.
Open it in the simulatorThe DS3231 keeps time with its own crystal and a coin cell, temperature compensated to about a minute a year. Read it, set it, and see the seconds that the tide math runs on.
Open it in the simulatorMake it yours: your port’s high tide, a hand that turns the right way behind your dial, and a cycle check before it goes on the wall.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Two bulges and a turning Earth, the 12 h 25 min cycle, and coasts that do not follow it.
The Moon pulls the oceans into two bulges and the Earth turns under them, so most coasts get two high tides a day. Meet the clock that shows it.
0 of 4 steps
Why the tides come 50 minutes later every day, the one number the clock needs, and the honest truth about how well an average fits a real coast.
0 of 4 steps
A servo hand mapped onto the cycle, and a real-time clock that keeps going.
A hobby servo goes to any angle from 0 to 180 and stays there: just right for a half-circle tide dial. Map the cycle onto it, and fix a servo mounted backward.
0 of 4 steps
The DS3231 keeps time with its own crystal and a coin cell, temperature compensated to about a minute a year. Read it, set it, and see the seconds that the tide math runs on.
0 of 4 steps
One high tide from a table, the drift of an average, and the finished wall clock.
One real high tide from your port’s tide table is all the clock needs. Set it, watch the average drift away from the real tides over a month, and know when to set it again.
0 of 4 steps
Make it yours: your port’s high tide, a hand that turns the right way behind your dial, and a cycle check before it goes on the wall.
0 of 4 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a tide clock is part of the maker track, a ladder of courses from zero to expert.
Build a real vending machine piece by piece: a keypad, a screen, coins and change, spirals, a drop sensor and service mode.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
An Uno, a real-time clock (DS3231) and a hobby servo: a hand that tracks the tides for your coast.
Open the kitPick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a tide clock are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 4 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: The 12 h 25 min cycle, RTC time and Project: a wall tide clock.
With "Tides in a sentence", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.