Measure what the panel makes
Add a small solar panel, a load and an INA219, and read real volts, milliamps and milliwatts. Why a panel is a current source, and how a shunt measures current.
Open it in the simulatorLight sensors and servos aim a panel, an INA219 measures it, and a fair experiment compares tracked with fixed.
0 of 3 done
3 lessons in 2 chapters, about 2 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Add a small solar panel, a load and an INA219, and read real volts, milliamps and milliwatts. Why a panel is a current source, and how a shunt measures current.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Steer two servos with four light sensors, then read real power off the panel.
Four light sensors in a cross steer a pan and tilt pair toward the brighter side. How a voltage divider turns light into a number, and how comparing two numbers aims a panel.
0 of 4 steps
Add a small solar panel, a load and an INA219, and read real volts, milliamps and milliwatts. Why a panel is a current source, and how a shunt measures current.
0 of 4 steps
Compare tracked with fixed using measured energy, and nothing else.
Run a fair experiment: twenty seconds tracking, twenty seconds parked, again and again, adding up the energy each way. Only measured numbers, never invented ones.
0 of 4 steps
All 3 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a solar tracker is part of the maker track, a ladder of courses from zero to expert.
An arc reactor style chest light and a moving faceplate in three builds: the glow, the helmet, then the whole suit.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 3 lessons of Build a solar tracker are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 2 hours: 3 lessons in 2 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Measure what the panel makes.
With "Four eyes and two servos", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.