Move detection
Turn reed events into moves: a lift and a place, a piece put back, and a capture made of two lifts, with every square debounced first.
Open it in the simulatorBuild a chessboard that knows where every piece is: reed switches and an expander, move detection, the rules, LED hints and a small engine to play.
0 of 6 done
6 lessons in 3 chapters, about 6 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Turn reed events into moves: a lift and a place, a piece put back, and a capture made of two lifts, with every square debounced first.
Open it in the simulatorLight the board: every piece dim, the last move in blue, and when a piece is picked, every square it may legally go to in green.
Open it in the simulatorThe finished board: moves from the reeds or the keyboard, LED hints, the engine's replies, a hint for you, and a fresh game when you want one.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Reed switches under the squares, and moves from lifts and places.
Read the squares of a chessboard: a reed switch under each, a magnet in every piece, and sixteen of them in one I2C read through an MCP23017.
0 of 5 steps
Turn reed events into moves: a lift and a place, a piece put back, and a capture made of two lifts, with every square debounced first.
0 of 5 steps
Every legal move, and lights that show them.
Teach the board the rules: a 0x88 board, every piece's moves, a king that may never be left in check, and checkmate and stalemate.
0 of 5 steps
Light the board: every piece dim, the last move in blue, and when a piece is picked, every square it may legally go to in green.
0 of 5 steps
A small engine with alpha-beta, then the finished board.
Give the board a mind: an evaluation, negamax with alpha-beta pruning three plies deep, captures first, and an honest look at how weak three plies is.
0 of 5 steps
The finished board: moves from the reeds or the keyboard, LED hints, the engine's replies, a hint for you, and a fresh game when you want one.
0 of 6 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build an electronic chessboard is part of the maker track, a ladder of courses from zero to expert.
A four-floor model lift on a stepper: calls and the elevator algorithm, a state machine, homing a lead screw hoist, doors with an eye, a safety chain, and a rush hour to measure it.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build an electronic chessboard are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 6 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Move detection, LED hints and Project: play the board.
With "Reed square matrix", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.