Find your kit
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitWhy volts times amps is not watts: phasors, reactance, impedance, real, reactive and apparent power, power factor, correction capacitors, and a motor's power bill, all on a 12 V bench.
0 of 7 done
7 lessons in 7 chapters, about 6 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.
Each lesson opens when the one before it is done, and each chapter ends in a project.
Two AC voltages that add up as a right triangle.
A scaled motor on 12 V AC: the resistor and the inductor read 7.2 V and 9.6 V, which add up to 12 V only as the sides of a right triangle. Phasors, the phase angle, and what frequency does to it.
0 of 6 steps
Ohms that grow with frequency in a coil and shrink in a capacitor.
An inductor and a capacitor, each alone on 12 V at 60 Hz: both draw 30 mA, so both are worth 400 ohms. Double the frequency and the inductor halves its current while the capacitor doubles it.
0 of 6 steps
Resistance and reactance at right angles, and a capacitor that cancels a coil.
The motor bench with a capacitor waiting in series: Z = V / I = 500 ohms, the square root of R squared plus X squared, a capacitor that raises the current, one that cancels the inductor, and one that makes the load capacitive.
0 of 6 steps
Watts, var and VA, and the triangle they make.
Volts times amps is not watts on AC: the bench takes 0.287 VA, the resistor turns 0.171 W into heat and the inductor borrows 0.229 var and gives it back. The power triangle, a pure heater, and a lighter load.
0 of 6 steps
An energy meter on a 120 V motor, and what the bill counts.
A PZEM-004T energy meter set up as a 120 V shop motor beside the 12 V bench: power factor is P / S, 0.6 for the motor, 1.0 for a heater and worse at light load, and the energy counter only counts the real watts.
0 of 6 steps
A capacitor beside the motor that shrinks the line current.
A capacitor across the motor supplies its reactive current locally: the line drops from 23.9 to 14.4 mA while the motor still takes 24, half a capacitor does half the job, three times too much is worse than none, and 0.95 is the practical target.
0 of 6 steps
Read a motor, size its capacitor, prove it on the bench.
A 120 V shop motor on the energy meter and its 12 V twin on the bench: read its PF, size a correction capacitor for 1.0 and then for 0.95, prove it on the bench, and write the before and after sheet for your own motor.
0 of 7 steps
All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 7 lessons of AC power are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.
About 6 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
With "Phasors without fear", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.