AC power lesson plan
Why volts times amps is not watts: phasors, reactance, impedance, real, reactive and apparent power, power factor, correction capacitors, and a motor's power bill, all on a 12 V bench.
Objectives and materials
By the end, students can
- Two AC voltages that add up as a right triangle.
- Ohms that grow with frequency in a coil and shrink in a capacitor.
- Resistance and reactance at right angles, and a capacitor that cancels a coil.
- Watts, var and VA, and the triangle they make.
- An energy meter on a 120 V motor, and what the bill counts.
- A capacitor beside the motor that shrinks the line current.
- Read a motor, size its capacitor, prove it on the bench.
Materials for the whole unit
- AC energy meter, PZEM-004T v3.0
- Arduino Uno R3
- Capacitor
- Function generator x 2
- Inductor
- Multimeter x 5
- Oscilloscope
- Resistor
- Slide switch
Every part is already on the simulator’s bench, so there is nothing to buy or hand out. The counts are the most any one lesson uses, if you build it on real breadboards too.
Phasors without fear
Two AC voltages that add up as a right triangle.
| Lesson | Time | What students do |
|---|---|---|
| Phasors without fearA scaled motor on 12 V AC: the resistor and the inductor read 7.2 V and 9.6 V, which add up to 12 V only as the sides of a right triangle. Phasors, the phase angle, and what frequency does to it. | 50 min |
|
Materials
- Function generator
- Inductor
- Multimeter x 4
- Oscilloscope
- Resistor
Check for understanding
Each student finishes "Phasors without fear" on their own, without opening the hints. The simulator checks 6 of its 6 steps as they go.
Then ask each one to explain, in a sentence or two, the last thing it asked of them: "Draw it yourself".
Reactance
Ohms that grow with frequency in a coil and shrink in a capacitor.
| Lesson | Time | What students do |
|---|---|---|
| Reactance: ohms that depend on frequencyAn inductor and a capacitor, each alone on 12 V at 60 Hz: both draw 30 mA, so both are worth 400 ohms. Double the frequency and the inductor halves its current while the capacitor doubles it. | 50 min |
|
Materials
- Capacitor
- Function generator x 2
- Inductor
- Multimeter x 4
Check for understanding
Each student finishes "Reactance: ohms that depend on frequency" on their own, without opening the hints. The simulator checks 6 of its 6 steps as they go.
Then ask each one to explain, in a sentence or two, the last thing it asked of them: "Where they meet".
Impedance
Resistance and reactance at right angles, and a capacitor that cancels a coil.
| Lesson | Time | What students do |
|---|---|---|
| Impedance: the whole oppositionThe motor bench with a capacitor waiting in series: Z = V / I = 500 ohms, the square root of R squared plus X squared, a capacitor that raises the current, one that cancels the inductor, and one that makes the load capacitive. | 50 min |
|
Materials
- Capacitor
- Function generator
- Inductor
- Multimeter x 4
- Oscilloscope
- Resistor
- Slide switch
Check for understanding
Each student finishes "Impedance: the whole opposition" on their own, without opening the hints. The simulator checks 6 of its 6 steps as they go.
Then ask each one to explain, in a sentence or two, the last thing it asked of them: "Too much capacitor".
Real, reactive and apparent
Watts, var and VA, and the triangle they make.
| Lesson | Time | What students do |
|---|---|---|
| Real, reactive and apparent powerVolts times amps is not watts on AC: the bench takes 0.287 VA, the resistor turns 0.171 W into heat and the inductor borrows 0.229 var and gives it back. The power triangle, a pure heater, and a lighter load. | 50 min |
|
Materials
- Function generator
- Inductor
- Multimeter x 4
- Oscilloscope
- Resistor
- Slide switch
Check for understanding
Each student finishes "Real, reactive and apparent power" on their own, without opening the hints. The simulator checks 6 of its 6 steps as they go.
Then ask each one to explain, in a sentence or two, the last thing it asked of them: "At motor size".
Power factor
An energy meter on a 120 V motor, and what the bill counts.
| Lesson | Time | What students do |
|---|---|---|
| Power factorA PZEM-004T energy meter set up as a 120 V shop motor beside the 12 V bench: power factor is P / S, 0.6 for the motor, 1.0 for a heater and worse at light load, and the energy counter only counts the real watts. | 50 min |
|
Materials
- AC energy meter, PZEM-004T v3.0
- Arduino Uno R3
- Function generator
- Inductor
- Multimeter x 4
- Oscilloscope
- Resistor
Check for understanding
Each student finishes "Power factor" on their own, without opening the hints. The simulator checks 6 of its 6 steps as they go.
Then ask each one to explain, in a sentence or two, the last thing it asked of them: "The meter bills real watts".
Correction capacitors
A capacitor beside the motor that shrinks the line current.
| Lesson | Time | What students do |
|---|---|---|
| Correction capacitorsA capacitor across the motor supplies its reactive current locally: the line drops from 23.9 to 14.4 mA while the motor still takes 24, half a capacitor does half the job, three times too much is worse than none, and 0.95 is the practical target. | 50 min |
|
Materials
- Capacitor
- Function generator
- Inductor
- Multimeter x 5
- Oscilloscope
- Resistor
- Slide switch
Check for understanding
Each student finishes "Correction capacitors" on their own, without opening the hints. The simulator checks 6 of its 6 steps as they go.
Then ask each one to explain, in a sentence or two, the last thing it asked of them: "In the real world".
Boss build
Read a motor, size its capacitor, prove it on the bench.
| Lesson | Time | What students do |
|---|---|---|
| Boss build: a motor's power billA 120 V shop motor on the energy meter and its 12 V twin on the bench: read its PF, size a correction capacitor for 1.0 and then for 0.95, prove it on the bench, and write the before and after sheet for your own motor. | 60 min |
|
Materials
- AC energy meter, PZEM-004T v3.0
- Arduino Uno R3
- Capacitor
- Function generator
- Inductor
- Multimeter x 5
- Oscilloscope
- Resistor
- Slide switch
Check for understanding
Each student finishes "Boss build: a motor's power bill" on their own, without opening the hints. The simulator checks 7 of its 7 steps as they go.
Then ask each one to explain, in a sentence or two, the last thing it asked of them: "Your power bill sheet".
Teach this unit as a class
Start a class from this course and its 7 lessons are assigned in one go, in order. Students join with a six-character code or printed login cards, and each one’s work comes back to you.
The class tools are free for 30 days for one class of up to 20 students, with no card. The lessons themselves are free either way.