Arduino Uno'da trafik ışığı

// Traffic light: a pelican crossing with a button that actually does
// something.
//
//   pin 8   red      pin 11  walk
//   pin 9   amber    pin 2   request button, to GND, internal pull-up
//   pin 10  green
//
// The button is on INT0, so a press is caught by the interrupt even while
// loop() is asleep inside delay(). Without that the sketch would only notice a
// press if you happened to be holding the button when it got round to looking,
// which is exactly the bug every first crossing sketch has.
//
// Green is the resting state and it waits there for a request, but never for
// less than MIN_GREEN: a crossing that stopped the traffic the instant anyone
// asked would never let a car through.
//
// The WAIT lamp on the breadboard is not driven from here at all. It hangs off
// a 74HC04 inverter wired straight to the button line, so it lights the moment
// the contact closes, a reminder that not everything has to be the
// microcontroller's job.

const int RED = 8;
const int AMBER = 9;
const int GREEN = 10;
const int WALK = 11;
const int BUTTON = 2;

const unsigned long MIN_GREEN = 3000;
const unsigned long MAX_GREEN = 9000;
const unsigned long AMBER_MS = 1500;
const unsigned long WALK_MS = 4000;

volatile bool requested = false;

static void onPress() { requested = true; }

static void lights(int red, int amber, int green) {
  digitalWrite(RED, red ? HIGH : LOW);
  digitalWrite(AMBER, amber ? HIGH : LOW);
  digitalWrite(GREEN, green ? HIGH : LOW);
}

// Hold green until someone asks, or until the maximum runs out.
static void waitForRequest() {
  unsigned long started = millis();
  for (;;) {
    unsigned long waited = millis() - started;
    if (waited >= MAX_GREEN) return;
    noInterrupts();
    bool asked = requested;
    interrupts();
    if (asked && waited >= MIN_GREEN) return;
    delay(20);
  }
}

void setup() {
  pinMode(RED, OUTPUT);
  pinMode(AMBER, OUTPUT);
  pinMode(GREEN, OUTPUT);
  pinMode(WALK, OUTPUT);
  pinMode(BUTTON, INPUT_PULLUP);
  attachInterrupt(digitalPinToInterrupt(BUTTON), onPress, FALLING);
  Serial.begin(115200);
  Serial.println("Mokxi Arduino Uno: crossing ready, press the button");
}

void loop() {
  lights(0, 0, 1);
  Serial.println("green");
  waitForRequest();

  lights(0, 1, 0);
  Serial.println("amber");
  delay(AMBER_MS);

  lights(1, 0, 0);
  digitalWrite(WALK, HIGH);
  Serial.println("walk");
  delay(WALK_MS);

  // the flashing period at the end of the walk phase
  // The pelican's own ending: the walk lamp flashes to say "finish crossing"
  // while the drivers get a flashing amber, which means "go if the crossing
  // is clear". Then straight back to green. (A red-and-amber pair before
  // green is the junction signal's sequence, not a crossing's.)
  Serial.println("flashing amber");
  for (int i = 0; i < 12; i++) {
    int on = (i & 1) ? LOW : HIGH;
    digitalWrite(WALK, on);
    lights(0, on == HIGH, 0);
    delay(500);
  }
  digitalWrite(WALK, LOW);
  noInterrupts();
  requested = false;
  interrupts();
}