Which way is up
Read an MPU6050 register by register: 1 g at rest, a tilt lockout for the pad, and launch detected as three readings over 2.5 g.
Open it in the simulatorBring up a barometer and an IMU, catch apogee, then fly a full state machine that logs to microSD.
0 of 4 done
4 lessons in 2 chapters, about 4 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Read an MPU6050 register by register: 1 g at rest, a tilt lockout for the pad, and launch detected as three readings over 2.5 g.
Open it in the simulatorPut it all together: a self-test, an armed state, a seven-state flight, beeps you can hear in a field and every sample logged to microSD.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Turn pressure into height and acceleration into launch.
Turn a BMP280 into an altimeter: read the pressure, zero the pad, climb with the slider and keep the highest point you reach.
0 of 5 steps
Read an MPU6050 register by register: 1 g at rest, a tilt lockout for the pad, and launch detected as three readings over 2.5 g.
0 of 4 steps
Find apogee, open the door, and log every sample.
Filter a noisy altitude, work out the climb rate, find apogee without being fooled, and let the parachute door go with a servo.
0 of 6 steps
Put it all together: a self-test, an armed state, a seven-state flight, beeps you can hear in a field and every sample logged to microSD.
0 of 7 steps
All 4 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
An Uno, a barometer, a motion sensor, a microSD logger, a parachute servo and status lamps.
Open the kitPick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 4 lessons of Model rocket flight computer are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 4 hours: 4 lessons in 2 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Which way is up and The flight computer.
With "Altitude from air pressure", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.