Find your kit
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitCircuits with memory, from real 74HC chips: flip-flops, synchronous counters, shift registers, Moore and Mealy machines, state encoding and hazards. Ends with a traffic light timed and decoded in hardware.
0 of 7 done
7 lessons in 7 chapters, about 6 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.
Each lesson opens when the one before it is done, and each chapter ends in a project.
Edge triggering, set and reset, the forbidden state and the toggle.
Half a 74HC74: a D flip-flop that samples on the clock edge and holds, asynchronous set and reset, the forbidden state, and the toggle flip-flop that is half of every counter.
0 of 6 steps
Synchronous counting, terminal count, a decade and eight bits.
The 74HC161 synchronous counter: binary on four outputs, terminal count, wrapping at 16, a decade counter from one NAND gate, and a second chip cascaded for eight bits.
0 of 7 steps
Load, shift, serial in and a ring counter.
The 74HC194 universal shift register: parallel load, shift right, serial data in, and a ring counter made by feeding the last stage back to the first.
0 of 6 steps
Outputs from the state alone, or from the state and the input.
One button, two flip-flops, two outputs: a Moore machine that answers on the next clock and lasts one clock, and a Mealy machine that answers at once and depends on the input itself.
0 of 5 steps
Binary, Gray and one-hot, and what each one buys.
The same states, three ways to store them: binary in four flip-flops, Gray code where one bit changes at a time, and one-hot where every state has its own flip-flop.
0 of 5 steps
Bouncing clocks, glitches, ripple and metastability.
A counter clocked by a real push button counts a dozen for one press. Debounce it with an RC filter and a Schmitt trigger, and meet the other hazards of sequential logic: glitches, ripple and metastability.
0 of 4 steps
A timer, a decoder and a latch, then your own timing.
A traffic light with no processor: a 74HC161 is the timer, a 74HC04 and a 74HC08 decode its count into green, yellow and red, and a 74HC74 latches the WALK button. Finish the decode, prove a full cycle, then retime it.
0 of 7 steps
All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 7 lessons of Sequential logic design are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.
About 6 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
With "Flip-flop types", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.