Find your kit
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitWhat a logic chip really is under a meter: 74HC against CD4000, logic levels and the HCT fix for 3.3 V, fan-out, open drain, tri-state buses and contention, Schmitt inputs. Ends with a two-device bus and its arbiter.
0 of 7 done
7 lessons in 7 chapters, about 6 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.
Each lesson opens when the one before it is done, and each chapter ends in a project.
Stiff and fast against soft and wide-ranging, on a meter.
The same NOR gate in two families, each driving a 1 k load: how hard a 74HC output holds its level, how soft a CD4000B output is, and why the CD4000B still earns its place at 12 V.
0 of 4 steps
Where low ends and high begins, and why 3.3 V wants HCT.
Sweep a voltage into a 74HC04 and a 74HCT04 and find where each one stops calling it low: CMOS levels at half the supply, TTL levels at 1.4 V, and why a 3.3 V signal belongs on an HCT input.
0 of 5 steps
One output, more and more load, and when it gives up.
One output, more and more LEDs: watch the high level sag as the current rises, compare a 74HC output with a CD4000B one, and learn what fan-out means when the loads are other CMOS inputs.
0 of 5 steps
Pull low or let go: the wired-AND behind I2C.
Outputs that can only pull a line low, a resistor that pulls it high, and why any number of them can share one wire without ever fighting: the electrical heart of I2C.
0 of 5 steps
Taking turns, contention, and a transceiver.
Two drivers on one bus wire that take turns: drive high, drive low, or let go. What a fight looks like when two drive at once, and a 74HC245 transceiver that passes the bus to a second segment, or isolates it.
0 of 5 steps
Two thresholds, hysteresis, and a one-gate oscillator.
Find the two thresholds of a 74HC14: the input has to climb past one to switch and fall below a lower one to switch back. Then the same hysteresis makes an oscillator out of one gate, a resistor and a capacitor.
0 of 5 steps
Drivers, an arbiter, a receiver and a bridge.
Two devices share one bus wire through tri-state drivers, a CD4001 latch decides who may drive, a 74HC14 receives it, and a 74HC245 bridges it to a second segment. Prove each part, break the arbiter on purpose, then turn the bridge around.
0 of 7 steps
All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 7 lessons of Logic families and buses are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.
About 6 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
With "74HC vs CD4000", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.