Ghosting, and why every key gets a diode
Scan a membrane keypad that has no diodes, hold three keys on a rectangle and watch a fourth appear, then see how one diode per key stops it.
Open it in the simulatorScan a key matrix, see ghosting and the diode that stops it, then add layers, a knob and per-key light.
0 of 3 done
3 lessons in 2 chapters, about 3 hours on a simulated SparkFun Pro Micro. Free, in your browser, every step checked by the simulator.
Scan a membrane keypad that has no diodes, hold three keys on a rectangle and watch a fourth appear, then see how one diode per key stops it.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Rows, columns, the scan, and why every key gets a diode.
Why twelve keys need only seven pins: drive one row LOW at a time, read the columns, and find every key by its row and column.
0 of 5 steps
Scan a membrane keypad that has no diodes, hold three keys on a rectangle and watch a fourth appear, then see how one diode per key stops it.
0 of 5 steps
A layered keymap, an encoder and one LED per key.
Turn the matrix into a keyboard: a keymap with layers you hold and toggle, an encoder that scrolls or steps by layer, and one WS2812B per key.
0 of 6 steps
All 3 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 3 lessons of Custom keyboards from the matrix up are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated SparkFun Pro Micro with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 3 hours: 3 lessons in 2 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Ghosting, and why every key gets a diode.
With "Rows, columns and the scan", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.