Find your kit
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitThe sensors on a real machine and tank: proximity switches, NPN against PNP, floats, pressure transducers and the 4-20 mA loop that carries a reading across a plant. Ends with a tank controller and every interlock it needs.
0 of 7 done
7 lessons in 7 chapters, about 6 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Each lesson opens when the one before it is done, and each chapter ends in a project.
A box counter, its output, its range, and the four families.
An infrared proximity switch counts boxes on a conveyor. What its output does, how its range is set, and which industrial type, inductive, capacitive, photoelectric or ultrasonic, you would fit for each job.
0 of 6 steps
Sinking and sourcing sensors, and the pairing that never turns on.
Both output stages at 24 V with the PLC inputs they drive: a sinking sensor into a sourcing input, a sourcing sensor into a sinking one, the 5 mA an input card draws, and the wrong pairing that never turns on.
0 of 7 steps
Floats, off delays, high-water alarms and fail-safe NC contacts.
A sump pump controller with two float switches: pump on at one level, off after a delay, a high-water float that forces the pump on, normally open against normally closed, and a current check that proves the pump really runs.
0 of 7 steps
Offset and span, psi and bar, and pressure as depth.
A 0 to 100 psi transducer on a water line: 0.5 to 4.5 V ratiometric output, offset and span, psi to bar, and reading the depth of water from the pressure at the bottom of a tank.
0 of 6 steps
Live zero, the receiver, loop resistance and a broken loop.
A transmitter, a 24 V supply, a series meter and a 250 ohm receiver. Why a current, why 4 and not 0, what the receiver sees, how much cable a loop can drive, and what a broken loop reads.
0 of 7 steps
Milliamps to percent to engineering units, and faults that are not numbers.
The same loop into an Uno: milliamps back from the receiver volts, percent of span, and engineering units set by typing a range, including one that does not start at zero, plus a loop fault that refuses to print a number.
0 of 6 steps
Floats, a hatch interlock, pressure and quality checks, your own limit.
Fill a tank between two floats with every interlock a real one has: a proximity sensor proving the hatch is shut, a pressure transducer catching a dry run and a blocked discharge, a TDS probe holding off bad water, and a high float wired fail-safe. Then set your own limit.
0 of 8 steps
All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 7 lessons of Industrial sensors and 4-20 mA are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 6 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
With "Proximity sensors", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.