A calibrated plant sensor
A capacitive soil sensor turned into a moisture percentage you can trust, a light level, and a thirsty alert that does not flicker. A sensor only, with no pump.
Open it in the simulatorBuild the sensors and switches people put around the house on an ESP32-C3, and see how each reading reaches Home Assistant.
0 of 5 done
5 lessons in 3 chapters, about 5 hours on a simulated ESP32-C3-DevKitM-1. Free, in your browser, every step checked by the simulator.
A capacitive soil sensor turned into a moisture percentage you can trust, a light level, and a thirsty alert that does not flicker. A sensor only, with no pump.
Open it in the simulatorOn, off, brightness, color and effects with a smooth fade, from buttons on the strip or from the network, plus the power rules for real strips.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Read a room and a plant pot, and turn each reading into a message.
Temperature, humidity, light and motion on one board: the sensor Home Assistant users build first, and how each reading becomes a message.
0 of 5 steps
A capacitive soil sensor turned into a moisture percentage you can trust, a light level, and a thirsty alert that does not flicker. A sensor only, with no pump.
0 of 4 steps
Use a radar for occupancy and drive an LED strip that fades.
An RCWL-0516 radar, an off delay so a pause does not plunge you into the dark, and a light that only comes on when it is dark.
0 of 4 steps
On, off, brightness, color and effects with a smooth fade, from buttons on the strip or from the network, plus the power rules for real strips.
0 of 4 steps
Press a garage door button safely and know where the door really is.
A relay that presses the wall button for half a second and two reed switches that report where the door really is, with the safety rules that come first.
0 of 4 steps
All 5 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 5 lessons of Home Assistant devices are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated ESP32-C3-DevKitM-1 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 5 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: A calibrated plant sensor and An LED strip controller.
With "A room multisensor", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.