Prop 2: a candy bowl that grabs back
An HC-SR04 watches across the top of the bowl. A hand reaches in, a piezo cackles and a servo swings a rubber hand down. Distance, a debounce for sensors, and a servo show.
Open it in the simulatorFive porch props on the Uno, from a fog trigger to a talking skull, each one a complete build with the safety notes that go with it.
0 of 5 done
5 lessons in 3 chapters, about 5 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
An HC-SR04 watches across the top of the bowl. A hand reaches in, a piezo cackles and a servo swings a rubber hand down. Distance, a debounce for sensors, and a servo show.
Open it in the simulatorA servo jaw that moves in time with a spoken line. Two honest ways to sync a jaw to a voice, and the cue list this one uses, with BUSY to know when the line is really over.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Spot someone on the path and switch something big, safely and only once.
A PIR sees someone on the path and a relay presses the fog machine’s remote for a short burst, then a cooldown lets the fog drift. The safe way to let an Arduino switch something big.
0 of 5 steps
An HC-SR04 watches across the top of the bowl. A hand reaches in, a piezo cackles and a servo swings a rubber hand down. Distance, a debounce for sensors, and a servo show.
0 of 4 steps
Open a lid and work a jaw on time with a sound from a DFPlayer.
A radar hidden inside a box sees someone walk up. A servo throws the lid open, a DFPlayer screams and two red eyes flicker, then it shuts and waits for the porch to clear.
0 of 4 steps
A servo jaw that moves in time with a spoken line. Two honest ways to sync a jaw to a voice, and the cue list this one uses, with BUSY to know when the line is really over.
0 of 5 steps
Run lightning and candlelight on WS2812B strips at the same time.
A WS2812B strip throws lightning across a window while four LEDs on the sill flicker like candles, and a knob sets the storm. Two animations at once, with no delay() anywhere.
0 of 4 steps
All 5 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Five props for the porch: fog, a grabbing bowl, a jump scare, a skull and a window.
Open the kitPick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 5 lessons of Build a Halloween prop are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 5 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Prop 2: a candy bowl that grabs back and Prop 4: a talking skull.
With "Prop 1: a fog machine trigger", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.