Rs/R0 ratios
Turn AO into the element's resistance, then into the ratio the datasheet's chart is drawn in, then into parts per million.
Open it in the simulatorHeaters, Rs/R0, calibration, cross sensitivity and alarms on the cheap MQ sensors, and why a hobby build never replaces a listed detector.
0 of 7 done
7 lessons in 4 chapters, about 6 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Turn AO into the element's resistance, then into the ratio the datasheet's chart is drawn in, then into parts per million.
Open it in the simulatorEvery MQ sensor answers to many gases and cannot say which one it smells. Fool all three sensors on the bench.
Open it in the simulatorA CO alarm listed to UL 2034 decides by exposure over time, sounds a set pattern, tests itself and reports faults. Sketch the ideas, and learn why a sketch is never the alarm.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
A heated tin dioxide film, its warm-up, and the ratio its chart is drawn in.
Inside an MQ sensor is a heater and a film of tin dioxide. Watch a cold one read as gas, then settle, and learn why every gas sketch waits.
0 of 6 steps
Turn AO into the element's resistance, then into the ratio the datasheet's chart is drawn in, then into parts per million.
0 of 6 steps
Measure R0, and learn which gas a reading can and cannot name.
R0 varies by a factor of two or more between sensors. Measure it in clean air, and see what trusting the datasheet's typical value costs.
0 of 6 steps
Every MQ sensor answers to many gases and cannot say which one it smells. Fool all three sensors on the bench.
0 of 6 steps
Hysteresis, exposure over time, test buttons and faults, and what a listing means.
A reading that hovers near a threshold turns a simple alarm on and off all day. Two thresholds fix it.
0 of 7 steps
A CO alarm listed to UL 2034 decides by exposure over time, sounds a set pattern, tests itself and reports faults. Sketch the ideas, and learn why a sketch is never the alarm.
0 of 7 steps
A garage fume alarm that knows what it is not.
Put it together: warm-up lockout, calibration at boot, a fan on CO, a dose alarm, a fuel vapor alarm and a test button. A project that sits beside listed alarms, never in their place.
0 of 8 steps
All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 7 lessons of MQ gas sensors, honestly are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 6 hours: 7 lessons in 4 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Rs/R0 ratios, Cross sensitivity and What a listed detector does.
With "The heater and burn-in", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.