A magnet for a key
A reed switch hidden in the box opens to a magnet held in the right place for two seconds: a lock with no keyhole.
Open it in the simulatorA keypad, a magnet key, an RFID card, a tilt sequence and a light puzzle, each one a lesson, then the whole box with its lock.
0 of 7 done
7 lessons in 3 chapters, about 4 hours on a simulated Arduino Mega 2560. Free, in your browser, every step checked by the simulator.
A reed switch hidden in the box opens to a magnet held in the right place for two seconds: a lock with no keyhole.
Open it in the simulatorA photoresistor module counts flashes, with two thresholds so a flickering light is never counted twice. Three flashes light the fifth lamp.
Open it in the simulatorAll five puzzles in one box against a ten-minute clock, with hints that cost 30 seconds and a servo lock that opens only at the end.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
A code on a keypad and a magnet nobody can see.
Sixteen keys on eight wires: how a 4 x 4 keypad is scanned, and a code lock that lights the first lamp for the right year.
0 of 5 steps
A reed switch hidden in the box opens to a magnet held in the right place for two seconds: a lock with no keyhole.
0 of 5 steps
A card, a tilt and a flash of light, each read by a different sensor.
An MFRC522 reader on the SPI pins reads each card's UID, and only the card that ends in A7 opens the third lock.
0 of 5 steps
An MPU-6050 feels which way gravity points, so the box knows how it is tipped. Left, right, then forward lights the fourth lamp.
0 of 4 steps
A photoresistor module counts flashes, with two thresholds so a flickering light is never counted twice. Three flashes light the fifth lamp.
0 of 4 steps
The clock, the hint and the lock, then all five puzzles at once.
A one-minute clock on the LCD and the five lamps, a hint button that costs time, and a servo lock with a game master's release.
0 of 5 steps
All five puzzles in one box against a ten-minute clock, with hints that cost 30 seconds and a servo lock that opens only at the end.
0 of 6 steps
All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
A Mega, a keypad, a reed switch, a card reader, a motion sensor, a lock servo and a clock.
Open the kitPick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 7 lessons of Build an escape-room puzzle box are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Mega 2560 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 4 hours: 7 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: A magnet for a key, Three flashes of light and Escape the box.
With "A keypad code lock", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.