Blink and glance
Blinks on an uneven beat and glances that ease into place, both on millis() timers so neither waits for the other.
Open it in the simulatorAnimated eyes on a round display that blink, feel, react to touch, tilt and light, ending with a robot that misses you.
0 of 6 done
6 lessons in 3 chapters, about 4 hours on a simulated ESP32-C3-DevKitM-1. Free, in your browser, every step checked by the simulator.
Blinks on an uneven beat and glances that ease into place, both on millis() timers so neither waits for the other.
Open it in the simulatorA TTP223 pad makes the robot beam, too many pokes make it cross, and being ignored makes it lonely.
Open it in the simulatorEverything together: blinking, glancing, moods, touch, a temper, dizzy spells, bedtime in the dark and loneliness when ignored.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Two eyes on round glass, then blinks and glances that bring them to life.
Draw two rounded eyes on a GC9A01 and slide them across the glass by repainting only the edges that move.
0 of 4 steps
Blinks on an uneven beat and glances that ease into place, both on millis() timers so neither waits for the other.
0 of 4 steps
Moods as a table of numbers, and a touch pad that changes them.
Happy, sleepy, surprised, angry, lonely and dizzy as a handful of numbers each: lids, tilt, size and color, eased from one to the next.
0 of 4 steps
A TTP223 pad makes the robot beam, too many pokes make it cross, and being ignored makes it lonely.
0 of 4 steps
Tilt and light, then the whole robot together.
An MPU6050 tips the gaze and makes the robot dizzy when rocked; an LDR module sends it to sleep in the dark.
0 of 4 steps
Everything together: blinking, glancing, moods, touch, a temper, dizzy spells, bedtime in the dark and loneliness when ignored.
0 of 4 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a desk buddy robot is part of the robotics track, a ladder of courses from zero to expert.
Drive by counting wheel slots, see hazards, do the science, then send your rover on a full mission.
Open the next courseMotors, servos, sensors and PID control loops, then a rover, a claw machine and a balance bot, every lesson checked on a simulated board.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
An ESP32-C3, a round eye screen, a motion sensor, a touch pad, a light sensor and a piezo.
Open the kitPick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a desk buddy robot are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated ESP32-C3-DevKitM-1 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 4 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Blink and glance, Touch and feelings and Meet your desk buddy.
With "Two eyes on a round screen", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.