Find your kit
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitFrom a truth table to a working circuit: sum of products, Boolean algebra and De Morgan, Karnaugh maps, decoders, multiplexers as logic and comparators. Ends with a 7-segment decoder you design from its table.
0 of 7 done
7 lessons in 7 chapters, about 6 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.
Each lesson opens when the one before it is done, and each chapter ends in a project.
One product for every 1, ORed: XOR and a half adder.
Read a truth table row by row, write one product term for every 1, OR them together, and wire it: XOR from AND, OR and NOT, then as one gate, then grown into a half adder.
0 of 6 steps
The laws, De Morgan, and a MUX from NAND gates alone.
The two-way MUX from its equation, then rewritten with De Morgan's laws into four NAND gates: the same truth table from one kind of gate, which is how real chips are built.
0 of 4 steps
Circle the 1s: a full adder's carry, and a sum no map can shrink.
Map a full adder's carry onto a Karnaugh map, circle three pairs, and wire the simplest circuit: three ANDs and an OR instead of four four-input terms. Then the sum, which no map can shrink.
0 of 6 steps
A 74HC138, minterms, and a 2-to-4 decoder from gates.
A 74HC138 turns a 3-bit address into one active-low line out of eight, with three enables. Then finish a 2-to-4 decoder from gates and test every row.
0 of 5 steps
A truth table in eight wires: a full adder from two 74HC151s.
An 8-to-1 multiplexer is a universal 3-input function: wire its eight data inputs to the truth table's output column. Two 74HC151s make a full adder with no gates at all.
0 of 4 steps
A 74HC85, and XOR as a 1-bit difference detector.
A 74HC85 compares two 4-bit numbers and says greater, equal or less, with cascade inputs for wider words. Then the 1-bit version: an XOR is a "these differ" detector.
0 of 4 steps
Segment truth tables, a 74HC138, a NAND and an inverter.
Design a 2-bit 7-segment decoder: write each segment's truth table, notice that a 74HC138's active-low lines already are most of them, and finish the rest with a NAND and an inverter. Then add a decimal point of your own.
0 of 7 steps
All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 7 lessons of Combinational logic design are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.
About 6 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
With "Truth tables to equations", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.