Pedal jadinya
Membangun pedal efek digital memakai board yang sama di setiap pelajaran:
- The guitar: a function generator, sinus 220 Hz, 2 V puncak, dipusatkan di 0 V seperti sinyal pickup.
- The input: a 1 uF capacitor into A0, held at 2.5 V by two 10 k resistors: bias-nya.
- The brain: an Arduino Uno, ADC-nya berjalan bebas di A0 dan Timer 2 menginterupsi 15.625 kali per detik.
- Keluarannya: PWM 8-bit pada 62.5 kHz di pin 9, dihaluskan oleh 1 k dan 100 nF, lalu 1 uF ke sebuah piezo yang memperdengarkan nada yang diterimanya.
- Controls: a potentiometer on A1, and two footswitch: MUTE on pin 2 stops the strings, FX on pin 3 switches the effect.
Ini adalah pedal gitar digital. Beda dengan pedal sim racing di Build load cell pedals.
Cara kerjanya
In and out. The capacitor blocks DC and the divider puts the swing in the middle of the ADC's 0 to 5 V; the code subtracts 128 to take the bias off. Each interrupt takes the latest sample, runs the effect and writes OCR1A. The knob is read eight times a second by borrowing the ADC for a sample.
Gain and clipping. Multiply, then limit: hard clipping cuts flat at the rails; soft clipping bends through y = 1.5t - 0.5t^3 first, from a 256-entry table.
Delay. A ring buffer of 1,280 bytes, all the Uno's 2 KB can spare beside the stack: 81 ms at most. Feedback writes some of the echo back for repeats, and MUTE measures the tail.
Tremolo. A slow phase accumulator, an LFO, scales every sample between 1 - depth and 1, as a triangle or a square.
Wah. Chamberlin's state-variable filter in fixed point, its band-pass output swept from 200 Hz to 2 kHz by the knob or by an LFO for auto-wah.
Latency. Sample by sample, the output follows the input within a tick. Working in blocks of 64 or 256 adds 4.1 or 16.4 ms, measured with MUTE.
Kursusnya
- Audio masuk dan keluar: bias, ayunan, sampling dan Nyquist, dan kenapa masukan sungguhan butuh buffer.
- Gain and clipping: clean gain, hard and soft clipping, and harmonics.
- Delay: a ring buffer, feedback, the tail, and the 2 KB limit.
- Tremolo: laju, kedalaman, dan bentuk LFO.
- Wah: band-pass yang digeser, auto-wah, dan Q.
- Latensi: sampel demi sampel dibanding pemrosesan blok.
- Proyek: pedal dua efek: drive dan tremolo berantai, bypass, dan urutan yang ditukar.
Setiap langkah yang dicentang diuji terhadap rangkaian yang sedang berjalan.