Source: https://mokxi.com/teachers/plans/build-smart-beehive
Updated: 2026-11-19

Lesson plan

# Build a smart beehive lesson plan

Build a hive monitor beekeepers can trust: weight trends, brood temperature, hive sound, a swarm watch and LoRa reports.

3 chapters, 6 lessons, about 5 hours, on the Arduino Uno R3. Every lesson runs in the browser, with nothing to install.

Start a class from this course

The unit

## Objectives and materials

### By the end, students can

- Weight and the brood nest's climate.
- Hive sound, and an alarm that needs two clues.
- Ten bytes over LoRa, then a season of data.

### Materials for the whole unit

- Arduino Uno R3
- Full-size breadboard
- Function generator
- Load cell with HX711
- LoRa module, SX1278 (Ra-02)
- Temperature and humidity, SHT31

Every part is already on the simulator’s bench, so there is nothing to buy or hand out. The counts are the most any one lesson uses, if you build it on real breadboards too.

Chapter 1. About 1 h 40 min

## Read the hive

Weight and the brood nest's climate.

Lesson | Time | What students do

Hive weight Weigh a whole beehive with load cells and an HX711, and read the trend: a nectar flow puts weight on, a swarm takes it off in minutes. | 50 min

- A hive on a scale
- Why no tare
- A nectar flow
- A sudden drop

Temperature and humidity Put an SHT31 in the brood box and read the colony's own thermostat: brood held near 34.5 C, whatever the weather. | 50 min

- 34.5 degrees
- Raising young
- A hot day
- No brood heat

### Materials

- Arduino Uno R3
- Full-size breadboard
- Function generator
- Load cell with HX711
- LoRa module, SX1278 (Ra-02)
- Temperature and humidity, SHT31

### Check for understanding

Each student finishes "Temperature and humidity" on their own, without opening the hints. The simulator checks 4 of its 4 steps as they go.

Then ask each one to explain, in a sentence or two, the last thing it asked of them: "No brood heat".

Chapter 2. About 1 h 40 min

## Listen for a swarm

Hive sound, and an alarm that needs two clues.

Lesson | Time | What students do

Hive sound Listen to a colony: the pitch from zero crossings, the level as RMS, and a careful watch on the band where young queens pipe. | 50 min

- The hum
- How loud
- Piping
- Quiet

Swarm signs Combine two clues into one alarm: a weight drop of 1.5 kg in ten minutes, and piping heard in the last half hour. | 50 min

- Calm
- A drop alone
- Piping alone
- Both

### Materials

- Arduino Uno R3
- Full-size breadboard
- Function generator
- Load cell with HX711
- LoRa module, SX1278 (Ra-02)
- Temperature and humidity, SHT31

### Check for understanding

Each student finishes "Swarm signs" on their own, without opening the hints. The simulator checks 4 of its 4 steps as they go.

Then ask each one to explain, in a sentence or two, the last thing it asked of them: "Both".

Chapter 3. About 1 h 40 min

## Report the season

Ten bytes over LoRa, then a season of data.

Lesson | Time | What students do

LoRa reports Send the hive's state home in ten bytes over LoRa: weight, brood temperature, humidity, sound and a report number. | 50 min

- Out of range
- Ten bytes
- On the air
- A heavier hive

Project: a season of data The whole monitor: weight, brood climate, sound, the swarm watch and LoRa reports with the season so far. | 50 min

- Spring
- The flow
- Swarm season
- Your apiary

### Materials

- Arduino Uno R3
- Full-size breadboard
- Function generator
- Load cell with HX711
- LoRa module, SX1278 (Ra-02)
- Temperature and humidity, SHT31

### Check for understanding

Each student finishes "Project: a season of data" on their own, without opening the hints. The simulator checks 4 of its 4 steps as they go.

Then ask each one to explain, in a sentence or two, the last thing it asked of them: "Your apiary".

Your class

## Teach this unit as a class

Start a class from this course and its 6 lessons are assigned in one go, in order. Students join with a six-character code or printed login cards, and each one’s work comes back to you.

The class tools are free for 30 days for one class of up to 20 students, with no card. The lessons themselves are free either way.

Start a class from this course See the demo class

More units

## Other lesson plans

Electronics basics 20 lessons, about 10 h. Embedded on the Arduino Uno 16 lessons, about 12 h. Embedded on the ESP32-C3 13 lessons, about 11 h. Embedded on the Raspberry Pi Pico 7 lessons, about 6 h. Build your own fight stick 5 lessons, about 4 h. Embedded on the STM32F411 6 lessons, about 6 h. C++ on a board 13 lessons, about 10 h. Digital logic and memory 4 lessons, about 4 h. Interactive devices on the Uno 9 lessons, about 8 h. From gates to a computer 23 lessons, about 16 h. Build a claw machine 8 lessons, about 6 h. Every unit All the courses as ready-made units, on the teachers page.
