Source: https://mokxi.com/teachers/plans/build-escape-room-network
Updated: 2026-11-19

Lesson plan

# Build a networked escape room lesson plan

Three Unos on nRF24L01 radios run a three-room escape game: addresses, acks, retries, state sync, hints and resets from a game master panel.

3 chapters, 6 lessons, about 6 hours, on the Arduino Uno R3. Every lesson runs in the browser, with nothing to install.

Start a class from this course

The unit

## Objectives and materials

### By the end, students can

- Puzzles that know their answers, and the packets that carry the news.
- A panel that knows every room, sends hints and puts it all back.
- Rooms in order, a clock, and an escape worth sharing.

### Materials for the whole unit

- 2.4 GHz radio, nRF24L01+ x 3
- Addressable RGB LEDs
- Arduino Uno R3 x 3
- Keypad, 4x4
- Reed switch
- RFID reader, MFRC522

Every part is already on the simulator’s bench, so there is nothing to buy or hand out. The counts are the most any one lesson uses, if you build it on real breadboards too.

Chapter 1. About 2 h

## Nodes and messages

Puzzles that know their answers, and the packets that carry the news.

Lesson | Time | What students do

Puzzle nodes Meet the network: a game master and two puzzle nodes, a keypad code in the Lab, a key card in the Vault and a hidden magnet in the Study. | 60 min

- Three boards, one game
- A wrong code
- The right code
- The wrong key card
- The book on the shelf

Messages between nodes Eight bytes on the air: addresses, a message format of your own, hardware acks, retries on top, and message numbers that catch repeats. | 60 min

- Eight bytes
- Addresses
- The ack
- Nobody home
- Delivered at last

### Materials

- 2.4 GHz radio, nRF24L01+ x 3
- Addressable RGB LEDs
- Arduino Uno R3 x 3
- Keypad, 4x4
- Reed switch
- RFID reader, MFRC522

### Check for understanding

Each student finishes "Messages between nodes" on their own, without opening the hints. The simulator checks 5 of its 5 steps as they go.

Then ask each one to explain, in a sentence or two, the last thing it asked of them: "Delivered at last".

Chapter 2. About 2 h 45 min

## The game master

A panel that knows every room, sends hints and puts it all back.

Lesson | Time | What students do

A game master panel A table of what the game master believes about every room, lights that show it, and a ping that makes the belief match the truth. | 60 min

- The panel
- What it does not know
- Ask them
- News arrives by itself
- Lock a room

Hints Send hints across the network to the right room, count them, and make each one a little more direct than the last. | 60 min

- A nudge
- A bigger nudge
- The right address
- One node, two rooms
- Keep score

Resets Put every room back for the next group with one command, check every node acknowledged it, and confirm with a ping. | 45 min

- After a game
- One command
- The node does it
- Check it

### Materials

- 2.4 GHz radio, nRF24L01+ x 3
- Addressable RGB LEDs
- Arduino Uno R3 x 3
- Keypad, 4x4
- Reed switch
- RFID reader, MFRC522

### Check for understanding

Each student finishes "Resets" on their own, without opening the hints. The simulator checks 4 of its 4 steps as they go.

Then ask each one to explain, in a sentence or two, the last thing it asked of them: "Check it".

Chapter 3. About 1 h 20 min

## A three-room game

Rooms in order, a clock, and an escape worth sharing.

Lesson | Time | What students do

Project: a three-room game The whole game: rooms that unlock in order, a 60-minute clock, hints that cost time, and an escape time at the end. | 80 min

- The game master
- Start the clock
- Not yet
- The Lab first
- Then the Vault
- Out
- Make it yours

### Materials

- 2.4 GHz radio, nRF24L01+ x 3
- Addressable RGB LEDs
- Arduino Uno R3 x 3
- Keypad, 4x4
- Reed switch
- RFID reader, MFRC522

### Check for understanding

Each student finishes "Project: a three-room game" on their own, without opening the hints. The simulator checks 7 of its 7 steps as they go.

Then ask each one to explain, in a sentence or two, the last thing it asked of them: "Make it yours".

Your class

## Teach this unit as a class

Start a class from this course and its 6 lessons are assigned in one go, in order. Students join with a six-character code or printed login cards, and each one’s work comes back to you.

The class tools are free for 30 days for one class of up to 20 students, with no card. The lessons themselves are free either way.

Start a class from this course See the demo class

More units

## Other lesson plans

Electronics basics 20 lessons, about 10 h. Embedded on the Arduino Uno 16 lessons, about 12 h. Embedded on the ESP32-C3 13 lessons, about 11 h. Embedded on the Raspberry Pi Pico 7 lessons, about 6 h. Build your own fight stick 5 lessons, about 4 h. Embedded on the STM32F411 6 lessons, about 6 h. C++ on a board 13 lessons, about 10 h. Digital logic and memory 4 lessons, about 4 h. Interactive devices on the Uno 9 lessons, about 8 h. From gates to a computer 23 lessons, about 16 h. Build a claw machine 8 lessons, about 6 h. Every unit All the courses as ready-made units, on the teachers page.
