Source: https://mokxi.com/learn/path/spice-simulation
Updated: 2026-11-20

All paths

# SPICE simulation

What a circuit simulator really does, on the SPICE engine Mokxi runs underneath: netlists, the operating point, transient and AC analysis, sweeps, models from datasheets, and a preamp verified before it is built.

Free 7 lessons 6 h 7 chapters 1,711 XP Electrical · Advanced +250 XP

0 of 7 done

Start the course free Netlists: a circuit as text Lesson plan for teachers

What you will build

## 0 projects, built step by step

7 lessons in 7 chapters, about 6 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.

The map

## Chapter by chapter

Each lesson opens when the one before it is done, and each chapter ends in a project.

Chapter 1

## Netlists

A circuit as text: nodes, ground and one line per part.

Open 265 XP

### Netlists: a circuit as text

Read and write the text every SPICE engine runs: nodes, ground as node 0, one line per part, SPICE's 0 V ammeter, and the same divider as a canvas and as a deck.

0 of 6 steps

Start What is in it

3 questions, graded as you go.

Chapter 2

## Operating point

Every node at DC, and where power-on differs from .op.

Locked 250 XP

### The operating point

What .op solves: every node voltage of a transistor stage at once, how a bias change moves it, Mokxi's Shift+O readout, and the one place power-on and SPICE's .op disagree.

0 of 5 steps

3 questions, graded as you go.

Chapter 3

## Transient

The circuit in time, read in multiples of tau.

Locked 265 XP

### Transient analysis

The circuit stepped through time: an RC fed a square wave, the time constant against the half period, what one tau, two and five look like, and the same run written as a .tran deck.

0 of 6 steps

3 questions, graded as you go.

Chapter 4

## AC sweep

A Bode plot proved point by point.

Locked 227 XP

### AC sweep

What an .ac analysis computes and how a scope proves it point by point: an RC low-pass a decade above its corner, at the corner, below it, a moved corner, and the Bode plot in the Analysis sheet.

0 of 5 steps

3 questions, graded as you go.

Chapter 5

## Parameter sweeps

60 mV a decade and a Zener's knee.

Locked 250 XP

### Parameter sweeps

Step one value and watch another: a transistor's current against its base voltage, 60 mV per decade, a Zener found by sweeping its supply, and the Analysis sheet's DC and parameter sweep.

0 of 5 steps

3 questions, graded as you go.

Chapter 6

## Models from datasheets

hFE, Vce(sat), GBW and the .model card.

Locked 227 XP

### Models from datasheets

Turn datasheet numbers into model parameters: hFE into beta, Vce(sat) at its test condition, an op-amp's gain-bandwidth product checked at its own bandwidth, and the .model card behind it all.

0 of 5 steps

3 questions, graded as you go.

Chapter 7

## Boss build

Predict, verify and change a preamp before you build it.

Locked 227 XP

### Boss: verify before you build

Design a microphone preamp on paper, predict its operating point and gain, verify every number in the simulator, then change the design to a new spec and verify again before a single part is bought.

0 of 5 steps

3 questions, graded as you go.

Syllabus

## Every lesson in the course

All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.

Chapter 1

### Netlists

- Netlists: a circuit as text Read and write the text every SPICE engine runs: nodes, ground as node 0, one line per part, SPICE's 0 V ammeter, and the same divider as a canvas and as a deck.

Chapter 2

### Operating point

- The operating point What .op solves: every node voltage of a transistor stage at once, how a bias change moves it, Mokxi's Shift+O readout, and the one place power-on and SPICE's .op disagree.

Chapter 3

### Transient

- Transient analysis The circuit stepped through time: an RC fed a square wave, the time constant against the half period, what one tau, two and five look like, and the same run written as a .tran deck.

Chapter 4

### AC sweep

- AC sweep What an .ac analysis computes and how a scope proves it point by point: an RC low-pass a decade above its corner, at the corner, below it, a moved corner, and the Bode plot in the Analysis sheet.

Chapter 5

### Parameter sweeps

- Parameter sweeps Step one value and watch another: a transistor's current against its base voltage, 60 mV per decade, a Zener found by sweeping its supply, and the Analysis sheet's DC and parameter sweep.

Chapter 6

### Models from datasheets

- Models from datasheets Turn datasheet numbers into model parameters: hFE into beta, Vce(sat) at its test condition, an op-amp's gain-bandwidth product checked at its own bandwidth, and the .model card behind it all.

Chapter 7

### Boss build

- Boss: verify before you build Design a microphone preamp on paper, predict its operating point and gain, verify every number in the simulator, then change the design to a new spec and verify again before a single part is bought.

Kits

## Build it on your bench too

Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.

Have a kit already?

### Find your kit

Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kit

Questions

## About SPICE simulation

Is SPICE simulation free?

Yes. All 7 lessons of SPICE simulation are free and run in your browser, with nothing to install and no parts to buy before you start.

Do I need any parts?

No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.

How long does SPICE simulation take?

About 6 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.

Where do I start?

With "Netlists: a circuit as text", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.
