Source: https://mokxi.com/learn/path/op-amp-cookbook
Updated: 2026-11-20

All paths

# Op-amp circuit cookbook

Advanced, after Transistors and op-amps for real: the integrator, differentiator, summing amp, instrumentation amp, precision rectifier and oscillators, ending in a strain gauge front end you scale yourself.

Free 7 lessons 6 h 7 chapters 1,939 XP Electrical · Advanced +250 XP

0 of 7 done

Start the course free Integrator Lesson plan for teachers

What you will build

## 0 projects, built step by step

7 lessons in 7 chapters, about 6 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.

The map

## Chapter by chapter

Each lesson opens when the one before it is done, and each chapter ends in a project.

Chapter 1

## Integrator

A capacitor in the feedback: the running total of the input.

Open 288 XP

### Integrator

A TL072 with a capacitor for feedback: a gain of exactly 1 at 159 Hz that halves every time the frequency doubles, a square wave turned into a triangle, and the 1 M resistor that keeps a tiny DC offset from slamming it into a rail.

0 of 6 steps

Start What is in it

4 questions, graded as you go.

Chapter 2

## Differentiator

A capacitor on the input: how fast the input moves, and its noise.

Locked 265 XP

### Differentiator

Swap the capacitor and resistor: a gain that rises with frequency, 1 at 159 Hz and 2 at 318, a triangle turned into a square, and the series resistor that keeps it from amplifying every bit of noise.

0 of 6 steps

3 questions, graded as you go.

Chapter 3

## Summing amp

Inputs that add at a virtual ground, and a 3-bit DAC.

Locked 265 XP

### Summing amp

An NE5532 adding three inputs at a virtual ground: binary-weighted resistors make a 3-bit DAC, every input adds without touching the others, and one resistor sets the full scale.

0 of 6 steps

3 questions, graded as you go.

Chapter 4

## Instrumentation amp

Millivolts from a bridge, with the common part thrown away.

Locked 265 XP

### Instrumentation amp

A strain gauge bridge gives 12 mV on top of 2.5 V: two OP07 buffers and a difference stage amplify the 12 mV and ignore the 2.5 V, one resistor sets the gain, and an op-amp's offset shows why precision parts exist.

0 of 6 steps

4 questions, graded as you go.

Chapter 5

## Precision rectifier

Diodes inside the loop, and an absolute value circuit.

Locked 265 XP

### Precision rectifier

A 0.3 V signal that a plain diode cannot rectify at all: diodes inside an op-amp's feedback lose their 0.6 V, a half-wave stage and a summing stage make a full-wave absolute value, and one wrong resistor breaks it.

0 of 6 steps

3 questions, graded as you go.

Chapter 6

## Oscillators

A relaxation square wave and a Wien bridge sine.

Locked 288 XP

### Oscillators

Two oscillators on one TL072: a relaxation square wave at 451 Hz that halves with twice the capacitor, and a Wien bridge sine at 158 Hz that lives on a gain of exactly 3 and dies on 2.8.

0 of 6 steps

4 questions, graded as you go.

Chapter 7

## Boss build

A strain gauge front end for a 0 to 5 V ADC.

Locked 303 XP

### Boss build: a strain gauge front end

A bridge on a long, humming cable into an in-amp sitting on a 2.5 V reference and a 16 Hz low pass: reject the hum, scale the gauge to fill a 0 to 5 V ADC both ways, then re-design it for a gauge four times less sensitive.

0 of 7 steps

4 questions, graded as you go.

Syllabus

## Every lesson in the course

All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.

Chapter 1

### Integrator

- Integrator A TL072 with a capacitor for feedback: a gain of exactly 1 at 159 Hz that halves every time the frequency doubles, a square wave turned into a triangle, and the 1 M resistor that keeps a tiny DC offset from slamming it into a rail.

Chapter 2

### Differentiator

- Differentiator Swap the capacitor and resistor: a gain that rises with frequency, 1 at 159 Hz and 2 at 318, a triangle turned into a square, and the series resistor that keeps it from amplifying every bit of noise.

Chapter 3

### Summing amp

- Summing amp An NE5532 adding three inputs at a virtual ground: binary-weighted resistors make a 3-bit DAC, every input adds without touching the others, and one resistor sets the full scale.

Chapter 4

### Instrumentation amp

- Instrumentation amp A strain gauge bridge gives 12 mV on top of 2.5 V: two OP07 buffers and a difference stage amplify the 12 mV and ignore the 2.5 V, one resistor sets the gain, and an op-amp's offset shows why precision parts exist.

Chapter 5

### Precision rectifier

- Precision rectifier A 0.3 V signal that a plain diode cannot rectify at all: diodes inside an op-amp's feedback lose their 0.6 V, a half-wave stage and a summing stage make a full-wave absolute value, and one wrong resistor breaks it.

Chapter 6

### Oscillators

- Oscillators Two oscillators on one TL072: a relaxation square wave at 451 Hz that halves with twice the capacitor, and a Wien bridge sine at 158 Hz that lives on a gain of exactly 3 and dies on 2.8.

Chapter 7

### Boss build

- Boss build: a strain gauge front end A bridge on a long, humming cable into an in-amp sitting on a 2.5 V reference and a 16 Hz low pass: reject the hum, scale the gauge to fill a 0 to 5 V ADC both ways, then re-design it for a gauge four times less sensitive.

Kits

## Build it on your bench too

Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.

Have a kit already?

### Find your kit

Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kit

Questions

## About Op-amp circuit cookbook

Is Op-amp circuit cookbook free?

Yes. All 7 lessons of Op-amp circuit cookbook are free and run in your browser, with nothing to install and no parts to buy before you start.

Do I need any parts?

No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.

How long does Op-amp circuit cookbook take?

About 6 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.

Where do I start?

With "Integrator", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.
