Source: https://mokxi.com/learn/path/audio-amplifiers
Updated: 2026-11-20

All paths

# Audio electronics

Advanced, after the Op-amp circuit cookbook: preamps, tone controls, amplifier classes, distortion, speakers and impedance, hum and noise, and a class A guitar amp channel you voice yourself.

Free 7 lessons 6 h 7 chapters 1,856 XP Electrical · Advanced +250 XP

0 of 7 done

Start the course free Preamps Lesson plan for teachers

What you will build

## 0 projects, built step by step

7 lessons in 7 chapters, about 6 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.

The map

## Chapter by chapter

Each lesson opens when the one before it is done, and each chapter ends in a project.

Chapter 1

## Preamps

Gain, input impedance, headroom and a log volume pot.

Open 288 XP

### Preamps

A guitar into a TL072 preamp: gain in decibels, the input impedance a pickup needs, the headroom a hot pickup eats, and why a volume knob is a log pot.

0 of 6 steps

Start What is in it

4 questions, graded as you go.

Chapter 2

## Tone controls

A treble cut and a bass cut, each one RC corner.

Locked 250 XP

### Tone controls

A guitar's own treble-cut knob and a bass-cut coupling capacitor, each buffered by half a TL072: a 723 Hz corner that darkens the highs and leaves the lows alone, and a 159 Hz corner that thins the bass.

0 of 5 steps

3 questions, graded as you go.

Chapter 3

## Amplifier classes

Where the watts go in class AB and class A.

Locked 250 XP

### Amplifier classes

Where a power amp's watts go: a class AB push-pull stage that idles at 190 mA and reaches 31 percent at full drive, and a class A stage that burns 22 W to deliver 2. The efficiency arithmetic behind class D.

0 of 5 steps

4 questions, graded as you go.

Chapter 4

## Distortion

Soft clipping, hard clipping and asymmetry.

Locked 288 XP

### Distortion

A TL072 gain stage into back-to-back diodes: a clipper that leaves a small signal alone and squashes a big one, a drive knob that changes the sound more than the level, asymmetric clipping that adds DC, and the hard clip of the rails.

0 of 6 steps

3 questions, graded as you go.

Chapter 5

## Speakers and impedance

Watts into ohms, cables and damping factor.

Locked 288 XP

### Speakers and impedance

An amp into an 8 ohm speaker: P = V squared over R, a 4 ohm load that doubles the watts, a thin cable that steals them, a tube amp's output impedance and damping factor, and why half the volts is a quarter of the power.

0 of 6 steps

3 questions, graded as you go.

Chapter 6

## Hum and noise

Ground loops, balanced inputs and grounding rules.

Locked 265 XP

### Hum and noise

A ground loop puts 60 Hz under the guitar: a single-ended input amplifies it, a balanced input throws it away, a high pass only half helps, and a 120 Hz buzz gets through more. The grounding rules that prevent it.

0 of 6 steps

3 questions, graded as you go.

Chapter 7

## Boss build

A class A guitar amp channel, voiced by you.

Locked 227 XP

### Boss build: a class A guitar amp channel

A whole channel: a TL072 preamp with a gain knob, diode overdrive, a tone knob, a power stage and a class A TIP41C into an 8 ohm load. Set it clean, then dirty, read what the output stage burns, and voice it yourself.

0 of 5 steps

3 questions, graded as you go.

Syllabus

## Every lesson in the course

All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.

Chapter 1

### Preamps

- Preamps A guitar into a TL072 preamp: gain in decibels, the input impedance a pickup needs, the headroom a hot pickup eats, and why a volume knob is a log pot.

Chapter 2

### Tone controls

- Tone controls A guitar's own treble-cut knob and a bass-cut coupling capacitor, each buffered by half a TL072: a 723 Hz corner that darkens the highs and leaves the lows alone, and a 159 Hz corner that thins the bass.

Chapter 3

### Amplifier classes

- Amplifier classes Where a power amp's watts go: a class AB push-pull stage that idles at 190 mA and reaches 31 percent at full drive, and a class A stage that burns 22 W to deliver 2. The efficiency arithmetic behind class D.

Chapter 4

### Distortion

- Distortion A TL072 gain stage into back-to-back diodes: a clipper that leaves a small signal alone and squashes a big one, a drive knob that changes the sound more than the level, asymmetric clipping that adds DC, and the hard clip of the rails.

Chapter 5

### Speakers and impedance

- Speakers and impedance An amp into an 8 ohm speaker: P = V squared over R, a 4 ohm load that doubles the watts, a thin cable that steals them, a tube amp's output impedance and damping factor, and why half the volts is a quarter of the power.

Chapter 6

### Hum and noise

- Hum and noise A ground loop puts 60 Hz under the guitar: a single-ended input amplifies it, a balanced input throws it away, a high pass only half helps, and a 120 Hz buzz gets through more. The grounding rules that prevent it.

Chapter 7

### Boss build

- Boss build: a class A guitar amp channel A whole channel: a TL072 preamp with a gain knob, diode overdrive, a tone knob, a power stage and a class A TIP41C into an 8 ohm load. Set it clean, then dirty, read what the output stage burns, and voice it yourself.

Kits

## Build it on your bench too

Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.

Have a kit already?

### Find your kit

Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kit

Questions

## About Audio electronics

Is Audio electronics free?

Yes. All 7 lessons of Audio electronics are free and run in your browser, with nothing to install and no parts to buy before you start.

Do I need any parts?

No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.

How long does Audio electronics take?

About 6 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.

Where do I start?

With "Preamps", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.
