Source: https://mokxi.com/ideas/waterlevel-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with a water level sensor

4 Mokxi projects use a water level sensor (2 beginner and 2 intermediate). They run on Arduino Uno and Raspberry Pi Pico boards. Here are all of them, from “Pico W water level sensor on GP28” to “Plant monitor”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Pico W water level sensor on GP28”, a beginner project that needs a water level sensor.
- Arduino Uno runs 3 of them and Raspberry Pi Pico 1. Start on the board you have, or on an Arduino Uno if you are buying one.
- The parts used most here are the capacitive soil moisture sensor (2 projects), the DC motor (1) and the I2C LCD (1). With those on hand, most of this list is open to you.
- Before you build one on a real bench, open the water level sensor part page for its pins and what each one does.

Projects

## 4 projects ready to run

### Pico W water level sensor on GP28

MicroPython on a Pico W: a water level sensor on GP28 reads higher as more of it is wet, and over 30000 the program warns of a leak.

Board

Raspberry Pi Pico W

Parts

Water level sensor

Level

Beginner

Open in the simulator

### Water level sensor

A water level sensor on A0: the sketch sorts the reading into dry, low, half and full and prints each change.

Board

Arduino Uno R3

Parts

Water level sensor

Level

Beginner

Open in the simulator

### Automatic plant waterer

A soil moisture stake, a relay and a small pump water a plant when it gets dry, in short bursts with time to soak.

Board

Arduino Uno R3

Parts

Capacitive soil moisture sensor, water level sensor, push button, relay module, DC motor, +2 more

Level

Intermediate

Open in the simulator

### Plant monitor

A soil moisture sensor, a rain sensor and a water level sensor on three analog pins. Two read lower when wetter and one reads higher.

Board

Arduino Uno R3

Parts

Capacitive soil moisture sensor, rain sensor, water level sensor, resistor, LED

Level

Intermediate

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The water level sensor part page Every project ideas list

### Library pages

- LiquidCrystal I2C library

### More project ideas

- Arduino Uno project ideas
- Raspberry Pi Pico project ideas
- Projects with a soil moisture sensor
- Projects with a DC motor
- Projects with an I2C LCD
- LED projects for Arduino, ESP32 and Pico
- Projects with a push button
- Projects with a relay module
