Source: https://mokxi.com/ideas/transistor-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with a transistor

37 Mokxi projects use a transistor (12 beginner, 18 intermediate and 7 advanced). They run on Arduino Uno, Raspberry Pi Pico and ESP32 boards. Here are 24, from “What is this part?” to “4x4x4 LED cube”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Passive buzzer alarm on pin 9, through a transistor”, a beginner project that needs a resistor, a transistor and a piezo speaker.
- Arduino Uno runs 15 of them, Raspberry Pi Pico 14 and ESP32 5. Start on the board you have, or on an Arduino Uno if you are buying one.
- The parts used most here are the LED (18 projects), the buzzer (14) and the push button (12). With those on hand, most of this list is open to you.
- Before you build one on a real bench, open the transistor part page for its pins and what each one does.

Projects

## 24 projects of 37

### What is this part?

Two component testers with unknown parts in the sockets: one names a transistor and finds its base, collector and emitter.

Board

No board

Parts

Transistor, LED, component tester

Level

Beginner

Open in the simulator

### Pico W passive buzzer plays notes with PWM

MicroPython on a Pico W: PWM on GP15 drives a passive buzzer through an S8050 and plays 440, 494 and 523 Hz, a quarter second each.

Board

Raspberry Pi Pico W

Parts

Piezo speaker, transistor, resistor

Level

Beginner

Open in the simulator

### Passive buzzer alarm on pin 9, through a transistor

A passive buzzer, switched by an NPN transistor from pin 9, wails like an alarm: the pitch rises and falls along a sine wave around 2 kHz.

Board

Arduino Uno R3

Parts

Resistor, transistor, piezo speaker

Level

Beginner

Open in the simulator

### NPN transistor switch

A 2N2222 switching an LED from a slide switch through a 1 k base resistor, with real Gummel-Poon currents in the base and collector.

Board

No board

Parts

Resistor, LED, transistor, slide switch

Level

Beginner

Open in the simulator

### Transistor doorbell: button on 12, buzzer on 9

Hold the push button on pin 12 (10k pull-up) and an active buzzer sounds, switched by an NPN transistor whose base is driven from pin 9.

Board

Arduino Uno R3

Parts

Push button, resistor, transistor, buzzer

Level

Beginner

Open in the simulator

### Pico W active buzzer beeps through an S8050

MicroPython on a Pico W: GP15 switches an S8050 that sounds an active buzzer: four short beeps, a pause of a second, and again.

Board

Raspberry Pi Pico W

Parts

Buzzer, transistor, resistor

Level

Beginner

Open in the simulator

### Motion light

A PIR module, a transistor and a lamp, no board. Click the dome and the light holds for two seconds after the movement stops.

Board

No board

Parts

PIR motion sensor, transistor, resistor, LED

Level

Beginner

Open in the simulator

### Vibration alarm: a spring switch on pin 3, a buzzer on 13

A spring vibration switch from pin 3 to ground fires an interrupt the moment it is shaken, and an active buzzer on pin 13.

Board

Arduino Uno R3

Parts

Resistor, transistor, buzzer, spring vibration switch

Level

Beginner

Open in the simulator

### Touchless soap dispenser

An FC-51 infrared obstacle sensor and a pump on a transistor: hold a hand under the spout and it pumps one dose, then waits for the hand to go away.

Board

Arduino Uno R3

Parts

Touchless soap dispenser, transistor, resistor, diode

Level

Beginner

Open in the simulator

### Motor on a transistor

A DC motor driven from pin 9 through a 2N2222, with a flyback diode across it. The PWM ramps up and down and the shaft follows.

Board

Arduino Uno R3

Parts

Transistor, resistor, diode, DC motor

Level

Intermediate

Open in the simulator

### MicroPython alarm on a Pico: a siren on a passive buzzer

MicroPython on a Raspberry Pi Pico: while the button on GP16 is held, PWM on GP15 sweeps a passive buzzer between 1 and 2 kHz like a siren.

Board

Raspberry Pi Pico

Parts

Resistor, transistor, piezo speaker, push button

Level

Intermediate

Open in the simulator

### Music box

A tune on an 8 ohm speaker through 100 ohms, a continuous-rotation servo turning the drum.

Board

Arduino Uno R3

Parts

Transistor, resistor, diode, vibration motor, 8 ohm speaker, +1 more

Level

Intermediate

Open in the simulator

### MicroPython IR remote dimmer on a Pico: keys 0 to 3

MicroPython on a Raspberry Pi Pico: remote keys 0 to 3, read by an IR receiver on GP16, set four levels for the LED on GP14 and beep a buzzer.

Board

Raspberry Pi Pico

Parts

IR receiver and remote, resistor, IR remote, LED, transistor, +1 more

Level

Intermediate

Open in the simulator

### Combination lock: keypad, servo bolt and buzzer

Type 1234 on a keypad (rows 11 to 8, columns 7 to 4) and a servo on pin 12 draws the bolt for two seconds; each key clicks a buzzer on pin 13.

Board

Arduino Uno R3

Parts

4x4 keypad, resistor, transistor, buzzer, servo motor

Level

Intermediate

Open in the simulator

### Remote dimmer: IR on 12, LED on 5, buzzer on 13

Buttons 0 to 3 on the remote set the LED on pin 5 to off, dim, medium and full; an active buzzer on pin 13, switched by an NPN transistor.

Board

Arduino Uno R3

Parts

Resistor, LED, transistor, buzzer, IR receiver and remote, +1 more

Level

Intermediate

Open in the simulator

### Smart blind stick

An HC-SR04 sets a buzzer and a vibration motor pulsing faster as an obstacle gets closer, and a water sensor at the tip chirps for a puddle.

Board

Arduino Uno R3

Parts

Transistor, resistor, diode, vibration motor, buzzer, +2 more

Level

Intermediate

Open in the simulator

### MicroPython alarm siren on a passive buzzer

MicroPython on an ESP32: while the button on GPIO 4 is held, a passive buzzer behind an S8050 on GPIO 13 wails between 1500 and 2500 Hz.

Board

ESP32-DevKitC V4

Parts

Piezo speaker, resistor, transistor, push button

Level

Intermediate

Open in the simulator

### Relay switches a motor: button on 12, relay on 9

Each press of the button on pin 12 flips a relay, driven from pin 9 through an NPN transistor with a diode across its coil.

Board

Arduino Uno R3

Parts

Push button, resistor, transistor, DPDT relay, diode, +3 more

Level

Intermediate

Open in the simulator

### Relays reverse a motor

Two motors turned both ways by relays: one on a two-channel board wired as an H bridge, one on a bare DPDT relay switched by a transistor.

Board

Arduino Uno R3

Parts

Resistor, transistor, diode, DPDT relay, DC motor, +1 more

Level

Intermediate

Open in the simulator

### MicroPython relay and motor on a Pico: a button toggles it

MicroPython on a Raspberry Pi Pico: each press of the button on GP15 flips a relay through a transistor on GP14, and the relay runs a DC motor.

Board

Raspberry Pi Pico

Parts

Resistor, transistor, push button, battery: AA, DPDT relay, +3 more

Level

Intermediate

Open in the simulator

### Pico W alarm siren and lamp on a slide switch

MicroPython on a Pico W: a slide switch on GP17 turns on a siren, a passive buzzer on GP15 sweeping 130 to 800 Hz with an LED on GP16 pulsing in step.

Board

Raspberry Pi Pico W

Parts

Piezo speaker, transistor, resistor, slide switch, capacitor, +1 more

Level

Intermediate

Open in the simulator

### Countdown timer on a four-digit display

A kitchen timer: a 74HC595 (pins 8, 13 and 12) and four digit lines on pins 2 to 5 show minutes and seconds.

Board

Arduino Uno R3

Parts

74HC595 shift register, four-digit seven-segment display, resistor, push button, LED, +2 more

Level

Advanced

Open in the simulator

### Pico W RFID music player with a WS2812 strip

MicroPython on a Pico W: lay an RFID card on an MFRC522 and the notes stored on it play on a passive buzzer while a WS2812 strip flashes a color per.

Board

Raspberry Pi Pico W

Parts

MFRC522 RFID reader, WS2812 NeoPixel LEDs, piezo speaker, transistor, resistor

Level

Advanced

Open in the simulator

### 4x4x4 LED cube

A 64 LED cube drawn as four labeled layers: two 74HC595s drive sixteen columns, four transistors switch the layers, and the Uno multiplexes rain.

Board

Arduino Uno R3

Parts

74HC595 shift register, push button, resistor, LED, transistor

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The transistor part page Every project ideas list

### Library pages

- Servo library
- IRremote library
- Keypad library

### More project ideas

- Arduino Uno project ideas
- Raspberry Pi Pico project ideas
- ESP32 project ideas
- Electronics projects with no code
- LED projects for Arduino, ESP32 and Pico
- Projects with a buzzer
- Projects with a push button
- Projects with a diode
- Projects with a piezo speaker
- Projects with a DPDT relay
- Projects with a DC motor
