Source: https://mokxi.com/ideas/stm32
Updated: 2026-11-17

Projects / Project ideas
Project ideas by board

# STM32 project ideas

7 Mokxi projects run on an STM32 board, all beginner. Here are all of them, from “Nucleo button” to “Nucleo fade”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Nucleo analog read”, a beginner project that needs a potentiometer.
- Every project here is a beginner project, so any one of them makes a fair first build.
- The parts used most here are the LED (5 projects), the potentiometer (1) and the push button (1). With those on hand, most of this list is open to you.
- STM32 pins are named by port and number (PA5, PC13), so read the pin labels in the circuit rather than an Arduino pin map.

Projects

## 7 projects ready to run

### Nucleo button

A pushbutton from PC13 to GND is the Nucleo’s USER button: pressing it lights the green LED on D13.

Board

STM32 Nucleo-F411RE

Parts

Push button

Level

Beginner

Open in the simulator

### STM32 tilt lamp

A tilt switch on PB0 of a Black Pill lights a lamp on PC13 while it stands upright. Tip it and the lamp goes dark.

Board

STM32F411 Black Pill

Parts

Resistor, LED, tilt switch

Level

Beginner

Open in the simulator

### Blue Pill lamp

A lamp on a Blue Pill that blinks in step with the board’s own LED, because both hang off 3.3 V and PC13 sinks them.

Board

STM32 Blue Pill (F103)

Parts

Resistor, LED

Level

Beginner

Open in the simulator

### Nucleo blink

The STM32 Nucleo-F411RE’s green LED on D13 and an LED beside the board, which light when the pin is HIGH, as on an Uno.

Board

STM32 Nucleo-F411RE

Parts

Resistor, LED

Level

Beginner

Open in the simulator

### STM32 chaser

A six-LED sweep that runs back and forth on the Black Pill, wired to PA1 through PA6.

Board

STM32F411 Black Pill

Parts

Resistor, LED

Level

Beginner

Open in the simulator

### Nucleo analog read

A potentiometer on A0 of an STM32 Nucleo-F411RE, read in ten bits and printed with its voltage.

Board

STM32 Nucleo-F411RE

Parts

Potentiometer

Level

Beginner

Open in the simulator

### Nucleo fade

analogWrite breathes an LED on D9 of an STM32 Nucleo-F411RE, at STM32duino’s 1 kHz PWM.

Board

STM32 Nucleo-F411RE

Parts

Resistor, LED

Level

Beginner

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The STM32F411 Black Pill board page Every project ideas list

### More project ideas

- LED projects for Arduino, ESP32 and Pico
- Projects with a potentiometer
- Projects with a push button
- Projects with a tilt switch
