Source: https://mokxi.com/ideas/slidepot-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with a slide potentiometer

5 Mokxi projects use a slide potentiometer (2 beginner and 3 advanced). They run on Arduino Uno, Pro Micro and Arduino Mega boards. Here are all of them, from “Big servo” to “MIDI controller”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Servo fader”, a beginner project that needs a slide potentiometer and a servo motor.
- Arduino Uno runs 2 of them, Pro Micro 2 and Arduino Mega 1. Start on the board you have, or on an Arduino Uno if you are buying one.
- The parts used most here are the servo motor (2 projects), the TM1637 four-digit display (2) and the arcade button (1). With those on hand, most of this list is open to you.
- Before you build one on a real bench, open the slide potentiometer part page for its pins and what each one does.

Projects

## 5 projects ready to run

### Big servo

An MG996R metal-gear servo on pin 9 follows a slide potentiometer on A0, powered from its own 6 V battery pack with only the ground shared.

Board

Arduino Uno R3

Parts

Slide potentiometer, servo, battery: AA

Level

Beginner

Open in the simulator

### Servo fader

A slide potentiometer on A0 sets the angle of a servo on pin 9. Push the fader and the horn follows.

Board

Arduino Uno R3

Parts

Slide potentiometer, servo motor

Level

Beginner

Open in the simulator

### H-pattern shifter and handbrake

Two pots read an H-pattern gate with hysteresis and push-down reverse, two microswitches make sequential paddles and a hall sensor is the handbrake.

Board

SparkFun Pro Micro

Parts

TM1637 four-digit display, limit switch, slide potentiometer, arcade button, 49E linear hall sensor

Level

Advanced

Open in the simulator

### Spaceship control panel

Arm three systems, pass the go/no-go poll, lift the safety and launch.

Board

Arduino Mega 2560 R3

Parts

Slide switch, LED arcade button, TM1637 four-digit display, piezo speaker, WS2812 NeoPixel LEDs, +7 more

Level

Advanced

Open in the simulator

### MIDI controller

Two faders, a knob, four drum pads and an encoder on a Pro Micro, sending real MIDI bytes the 5-pin way.

Board

SparkFun Pro Micro

Parts

Resistor, LED, slide potentiometer, push button, potentiometer, +1 more

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The slide potentiometer part page Every project ideas list

### Library pages

- Servo library
- TM1637 library
- Adafruit NeoPixel library
- Arduino Joystick library
- Encoder library
- LiquidCrystal I2C library

### More project ideas

- Arduino Uno project ideas
- Pro Micro and Leonardo project ideas
- Arduino Mega project ideas
- Servo motor projects
- Projects with a TM1637 display
- Projects with an arcade button
- Projects with a lit arcade button
- Projects with a joystick
- Projects with a 20x4 I2C LCD
- LED projects for Arduino, ESP32 and Pico
