Source: https://mokxi.com/ideas/servo-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Servo motor projects

67 Mokxi projects use a servo motor (21 beginner, 27 intermediate and 19 advanced). They run on Arduino Uno, Raspberry Pi Pico and ESP32 boards. Here are 24, from “ESP32-C3 servo” to “Spaceship control panel”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “ESP32-C3 servo”, a beginner project that needs a servo motor.
- Arduino Uno runs 54 of them, Raspberry Pi Pico 5 and ESP32 4. Start on the board you have, or on an Arduino Uno if you are buying one.
- The parts used most here are the push button (23 projects), the piezo speaker (18) and the LED (17). With those on hand, most of this list is open to you.
- Before you build one on a real bench, read the servo motor wiring guide for your board below. It gives every pin and the voltage notes.

Projects

## 24 projects of 67

### ESP32-C3 servo

Sweeps an SG90 end to end with a 50 Hz LEDC channel on GPIO 4: the pulse width is the angle, and the hardware keeps the frame while the core sleeps.

Board

ESP32-C3-DevKitM-1

Parts

Servo motor

Level

Beginner

Open in the simulator

### MicroPython servo sweep on a Pico, signal on GP16

MicroPython on a Raspberry Pi Pico: 50 Hz PWM on GP16 sweeps a servo from 0 to 180 degrees and back, one degree every 15 ms.

Board

Raspberry Pi Pico

Parts

Servo motor

Level

Beginner

Open in the simulator

### Dinosaur game player: light sensor on A0, servo on 9

A photoresistor on A0 watches the screen of the browser’s dinosaur game; when a dark cactus passes over it.

Board

Arduino Uno R3

Parts

Photoresistor, resistor, servo motor

Level

Beginner

Open in the simulator

### Power module

An MB102 breadboard power supply runs a servo off a 9 V battery, 5 V on the top rails and 3.3 V on the bottom.

Board

Arduino Uno R3

Parts

Battery: AA, servo motor

Level

Beginner

Open in the simulator

### Robotic hand with flex sensors

Robotic hand with flex sensors on an Arduino Mega: five flex sensors on a glove move five servo fingers, and the Serial Monitor names the gesture.

Board

Arduino Mega 2560 R3

Parts

Servo motor, flex sensor

Level

Beginner

Open in the simulator

### Servo sweep with RPi.GPIO PWM

RPi.GPIO software PWM at 50 Hz on a Raspberry Pi 4: a servo on GPIO18 steps from 0 to 180 degrees and back, one position a second.

Board

Raspberry Pi 4 Model B

Parts

Servo motor

Level

Beginner

Open in the simulator

### Cat laser toy

A KY-008 laser on a pan and tilt pair of servos wanders its dot around the floor for a minute, then rests until the button is pressed.

Board

Arduino Uno R3

Parts

Laser module, servo motor, push button

Level

Beginner

Open in the simulator

### Pico W servo sweep on GP15

MicroPython on a Pico W: 50 Hz PWM on GP15 sweeps an SG90 servo from 0 to 180 degrees and back, a pulse of 0.5 to 2.5 ms.

Board

Raspberry Pi Pico W

Parts

Servo motor

Level

Beginner

Open in the simulator

### Mood dial

Turn the potentiometer on A0 and the servo on pin 9 turns to match: map() stretches 0 to 1023 onto 0 to 179 degrees.

Board

Arduino Uno R3

Parts

Potentiometer, servo motor

Level

Beginner

Open in the simulator

### Grabbing candy bowl

An HC-SR04 watches across the top of a candy bowl: when a hand reaches in, a piezo cackles and a servo swings a rubber hand down to grab it.

Board

Arduino Uno R3

Parts

HC-SR04 ultrasonic sensor, servo motor, piezo speaker

Level

Beginner

Open in the simulator

### MicroPython servo knob on a Pico: a pot points the servo

MicroPython on a Raspberry Pi Pico: a potentiometer on GP26 sets the angle of a servo on GP15, from 0 to 180 degrees.

Board

Raspberry Pi Pico

Parts

Potentiometer, servo motor

Level

Beginner

Open in the simulator

### A knob on A0 points the servo on pin 3

A potentiometer on A0 sets the angle of a servo on pin 3: the reading from 0 to 1023 becomes an angle from 0 to 180 degrees.

Board

Arduino Uno R3

Parts

Potentiometer, servo motor

Level

Beginner

Open in the simulator

### Remote control light switch (IR on 12, servo on 11)

An IR receiver on pin 12 and a servo on pin 11: press 1 on the remote and the servo arm swings to flip a wall switch on, press 2 and it flips it off.

Board

Arduino Uno R3

Parts

IR receiver and remote, IR remote, servo motor

Level

Beginner

Open in the simulator

### Fingerprint door lock

An optical fingerprint sensor checks the finger on its glass: an enrolled one swings a servo latch open for three seconds.

Board

Arduino Uno R3

Parts

Fingerprint sensor, traffic light module, servo motor

Level

Intermediate

Open in the simulator

### Smart trash can: ultrasonic on 8 and 7, servo lid on 9

An HC-SR04 with TRIG on pin 8 and ECHO on 7 watches for a hand; closer than 20 cm and the servo on pin 9 swings the lid open.

Board

Arduino Uno R3

Parts

HC-SR04 ultrasonic sensor, servo motor

Level

Intermediate

Open in the simulator

### Radar sweep: ultrasonic on 10 and 11, servo on 12

An HC-SR04 (TRIG 10, ECHO 11) rides a servo on pin 12 that sweeps from 15 to 165 degrees and back.

Board

Arduino Uno R3

Parts

HC-SR04 ultrasonic sensor, servo motor

Level

Intermediate

Open in the simulator

### Combination lock: keypad, servo bolt and buzzer

Type 1234 on a keypad (rows 11 to 8, columns 7 to 4) and a servo on pin 12 draws the bolt for two seconds; each key clicks a buzzer on pin 13.

Board

Arduino Uno R3

Parts

4x4 keypad, resistor, transistor, buzzer, servo motor

Level

Intermediate

Open in the simulator

### RC plane elevon and V-tail mixer

An Arduino flight mixer: two joysticks stand in for the sticks, and two servos move as a flying wing’s elevons or a V-tail, picked by a switch.

Board

Arduino Uno R3

Parts

Servo motor, slide switch, joystick

Level

Intermediate

Open in the simulator

### Arduino quadruped robot

Eight servos on a PCA9685 walk a four-legged robot through a creep gait: one foot lifts and swings forward at a time while the other three hold it up.

Board

Arduino Uno R3

Parts

Servo driver, servo motor

Level

Advanced

Open in the simulator

### Pico W tilt controller: MPU6050 points a servo

MicroPython on a Pico W: the tilt of an MPU6050 on I2C1, worked out from gravity and averaged, turns a servo on GP15 to follow it.

Board

Raspberry Pi Pico W

Parts

MPU6050 accelerometer and gyro, servo motor

Level

Advanced

Open in the simulator

### MicroPython keypad door lock with a servo

MicroPython on an ESP32: type 1234 on a 4x4 keypad to swing the servo on GPIO 19 open; every key beeps a buzzer behind an S8050 on GPIO 18.

Board

ESP32-DevKitC V4

Parts

4x4 keypad, buzzer, resistor, transistor, servo motor

Level

Advanced

Open in the simulator

### Escape-room puzzle box

Five puzzles in ten minutes: a keypad code, a magnet key, the right RFID card, a tilt sequence and three flashes of light.

Board

Arduino Mega 2560 R3

Parts

4x4 keypad, reed switch, piezo speaker, MPU6050 accelerometer and gyro, servo motor, +6 more

Level

Advanced

Open in the simulator

### MPU6050 servo stabilizer

A self-leveling gimbal on an Uno: tilt the MPU6050 and two servos turn the other way to hold a platform level, through a complementary filter.

Board

Arduino Uno R3

Parts

Servo motor, MPU6050 accelerometer and gyro

Level

Advanced

Open in the simulator

### Spaceship control panel

Arm three systems, pass the go/no-go poll, lift the safety and launch.

Board

Arduino Mega 2560 R3

Parts

Slide switch, LED arcade button, TM1637 four-digit display, piezo speaker, WS2812 NeoPixel LEDs, +7 more

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The servo motor part page Every project ideas list

### Wiring guides

- servo to Arduino Uno
- servo to Arduino Mega
- servo to Raspberry Pi Pico
- servo to Arduino Nano
- servo to ESP32

### Library pages

- Servo library
- ESP32Servo library
- ServoEasing library
- VarSpeedServo library
- LiquidCrystal I2C library
- Adafruit NeoPixel library

### More project ideas

- Arduino Uno project ideas
- Raspberry Pi Pico project ideas
- ESP32 project ideas
- Arduino Mega project ideas
- Projects with a push button
- Projects with a piezo speaker
- LED projects for Arduino, ESP32 and Pico
- Projects with an I2C LCD
- Projects with a potentiometer
- Projects with a buzzer
- Projects with an ultrasonic sensor
