Source: https://mokxi.com/ideas/robots
Updated: 2026-11-17

Projects / Project ideas
Robots

# Robot projects for Arduino and ESP32

These are the projects with a robot chassis or a robot arm in the circuit, or a robot in the name. You will find cars, arms, walkers and a hexapod. Mokxi has 27 of them (2 beginner, 13 intermediate and 12 advanced). Here are 24, from “Robotic hand with flex sensors” to “Wheel-encoder square driver”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Robotic hand with flex sensors”, a beginner project that needs a servo motor and a flex sensor.
- Most of them are intermediate projects. Pick one a level below what you think you can do, finish it, then move up.
- The parts used most here are the 2WD robot car chassis (14 projects), the L298N motor driver (8) and the servo motor (8). With those on hand, most of this list is open to you.
- Start with a car that only drives forward and stops, then add one sensor at a time. The bugs in a robot are almost always in the last thing added.

Projects

## 24 projects of 27

### Robotic hand with flex sensors

Robotic hand with flex sensors on an Arduino Mega: five flex sensors on a glove move five servo fingers, and the Serial Monitor names the gesture.

Board

Arduino Mega 2560 R3

Parts

Servo motor, flex sensor

Level

Beginner

Open in the simulator

### Light-seeking robot

A two-wheel robot with a photoresistor module on each front corner.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, photoresistor module

Level

Beginner

Open in the simulator

### Joystick robot car with an L298N

A thumb stick on A1 and A2 drives a 2WD car on an L298N like a tank: throttle plus steer on one wheel, minus on the other, and a press for slow mode.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, joystick

Level

Intermediate

Open in the simulator

### Bumper car

A 2WD robot car on a DRV8833 with two lever microswitches for bumpers. It drives until a bumper is hit, then backs off and turns away from that side.

Board

Arduino Uno R3

Parts

DRV8833 motor driver, 2WD robot car chassis, limit switch

Level

Intermediate

Open in the simulator

### Bluetooth RC car with an HC-05

An HC-05 and a 2WD car on an L298N: type F, B, L, R or S in the module’s box, as a phone app sends them, and the car drives; 0 to 9 set the speed.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, HC-05 Bluetooth module, resistor

Level

Intermediate

Open in the simulator

### Obstacle-avoiding car

A 2WD robot car on an L298N with an HC-SR04 on the front. It drives ahead, and when something comes within 25 cm it backs up, turns and carries on.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, HC-SR04 ultrasonic sensor

Level

Intermediate

Open in the simulator

### TB6612 robot drive

Two gearbox motors on a TB6612FNG from a four-AA pack, with the SparkFun library: forward, half speed, a spin, reverse, a brake and standby.

Board

Arduino Uno R3

Parts

TB6612FNG motor driver, DC motor, battery: AA

Level

Intermediate

Open in the simulator

### Sumo robot

A mini-sumo robot with an ultrasonic eye and two edge sensors.

Board

Arduino Uno R3

Parts

DRV8833 motor driver, 2WD robot car chassis, HC-SR04 ultrasonic sensor, TCRT5000 line sensor

Level

Intermediate

Open in the simulator

### Infrared remote rover

A two-wheel robot driven from a 21-button infrared remote.

Board

Arduino Uno R3

Parts

MX1508 dual motor driver, 2WD robot car chassis, IR receiver and remote, IR remote

Level

Intermediate

Open in the simulator

### Robot car drive

Two gearbox motors on an L298N module from six Uno pins: forward, a turn, a spin on the spot and reverse, with the speed on ENA and ENB.

Board

Arduino Uno R3

Parts

L298N motor driver, DC motor

Level

Intermediate

Open in the simulator

### Maze-solving robot

A two-wheel robot with three Sharp infrared distance sensors.

Board

Arduino Uno R3

Parts

DRV8833 motor driver, 2WD robot car chassis, IR distance sensor

Level

Intermediate

Open in the simulator

### Scanning obstacle rover

A robot with an ultrasonic sensor on a servo neck. Blocked, it stops, looks right, ahead and left, picks the clearest way and turns that way.

Board

Arduino Uno R3

Parts

TB6612FNG motor driver, 2WD robot car chassis, servo motor, HC-SR04 ultrasonic sensor

Level

Intermediate

Open in the simulator

### Factory 3: Robot arm

A servo robot arm picks lumps off one belt and drops them on another. Tune its speed and grab time on two knobs and watch lumps get missed or slip.

Board

Arduino Uno R3

Parts

ILI9341 TFT display, servo motor, resistor, LED, piezo speaker, +1 more

Level

Intermediate

Open in the simulator

### Desk buddy robot

Animated robot eyes on a round GC9A01: it blinks and glances about, beams when you stroke it, gets dizzy when rocked and lonely when ignored.

Board

ESP32-C3-DevKitM-1

Parts

GC9A01 round display, MPU6050 accelerometer and gyro, touch sensor, photoresistor module, piezo speaker

Level

Advanced

Open in the simulator

### Robot arm inverse kinematics

Two knobs set where the claw should be in millimeters, and the Uno solves the shoulder and elbow angles with the law of cosines.

Board

Arduino Uno R3

Parts

Four-servo robot arm, potentiometer

Level

Advanced

Open in the simulator

### Mars rover

A rover that drives three waypoints by dead reckoning, steers around hazards it sees with a sonar mast, samples soil and light.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, push button, SSD1306 OLED display, VL53L0X time-of-flight sensor, +3 more

Level

Advanced

Open in the simulator

### Arduino quadruped robot

Eight servos on a PCA9685 walk a four-legged robot through a creep gait: one foot lifts and swings forward at a time while the other three hold it up.

Board

Arduino Uno R3

Parts

Servo driver, servo motor

Level

Advanced

Open in the simulator

### Wireless robot arm with nRF24L01

Two Unos and two nRF24L01 radios: joysticks on one board steer a four-servo arm on the other, with a failsafe that holds the arm when the link drops.

Board

Arduino Uno R3

Parts

NRF24L01+ 2.4 GHz radio, four-servo robot arm, joystick

Level

Advanced

Open in the simulator

### Pick and place arm on a PCA9685

A four-servo arm on a PCA9685 servo board with the Adafruit library: it picks a part up on one side, sets it down on the other and goes home.

Board

Arduino Uno R3

Parts

Servo driver, four-servo robot arm

Level

Advanced

Open in the simulator

### Hand gesture controlled car

Tilt an MPU6050 on your hand and a 2WD car follows over nRF24L01 radios: forward, reverse, left, right, and it stops when the signal is lost.

Board

Arduino Uno R3

Parts

NRF24L01+ 2.4 GHz radio, MPU6050 accelerometer and gyro, L298N motor driver, 2WD robot car chassis

Level

Advanced

Open in the simulator

### Fire fighting robot

Three flame sensors steer a 2WD car on an L298N to the fire, then a relay runs a water pump while a servo sweeps the nozzle until the flame is out.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, flame sensor, servo motor, relay module, +1 more

Level

Advanced

Open in the simulator

### Factory 8: Logistics robot

A delivery robot plans a route around the machines with A* search, fetches crates and brings them to the depot.

Board

Arduino Uno R3

Parts

ILI9341 TFT display, joystick, push button, servo motor, resistor, +2 more

Level

Advanced

Open in the simulator

### Hexapod robot

Twelve servos on a PCA9685 walk a six-legged robot with the tripod gait: three feet lift and swing forward while the other three hold it up.

Board

Arduino Uno R3

Parts

Servo driver, limit switch, servo motor

Level

Advanced

Open in the simulator

### Wheel-encoder square driver

A two-wheel robot that counts pulses from a slot sensor on each wheel.

Board

Arduino Uno R3

Parts

L9110S motor driver, 2WD robot car chassis

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

Every project ideas list

### Wiring guides

- L298N motor driver to Arduino Uno
- servo to Arduino Uno
- L298N motor driver to Arduino Mega
- servo to Arduino Mega
- joystick to Arduino Uno
- buzzer to Arduino Uno
- HC-SR04 to Arduino Uno
- potentiometer to Arduino Uno

### Library pages

- Servo library
- Adafruit PWM Servo Driver library
- Adafruit GFX library
- RF24 library
- Adafruit GC9A01A library
- Adafruit MPU6050 library

### More project ideas

- Arduino Uno project ideas
- Arduino Mega project ideas
- ESP32 project ideas
- Projects with a robot car chassis
- Projects with an L298N motor driver
- Servo motor projects
- Projects with a robot arm
- Projects with a DRV8833 motor driver
- Projects with a joystick
- Projects with an ultrasonic sensor
- Projects with a light sensor module
