Source: https://mokxi.com/ideas/pressuretransducer-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with a pressure transducer

4 Mokxi projects use a pressure transducer (1 beginner, 1 intermediate and 2 advanced). They run on Arduino Uno boards. Here are all of them, from “Water pressure gauge” to “Deep-sea dive computer”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Water pressure gauge”, a beginner project that needs a pressure transducer and an I2C LCD.
- All of them run on an Arduino Uno, so that is the one board you need.
- The parts used most here are the LED (2 projects), the push button (2) and the buzzer (1). With those on hand, most of this list is open to you.
- Before you build one on a real bench, open the 0.5 to 4.5 V pressure sender part page for its pins and what each one does.

Projects

## 4 projects ready to run

### Water pressure gauge

A 0.5 to 4.5 V stainless pressure transducer on a water line and a 16x2 I2C LCD: the pressure in psi and bar, with a warning when it drops.

Board

Arduino Uno R3

Parts

0.5 to 4.5 V pressure sender, I2C LCD

Level

Beginner

Open in the simulator

### Boost and oil pressure gauge

Oil pressure from a 0.5 to 4.5 V sender and boost or vacuum from an absolute MAP sensor on a 20x4 LCD, with a resettable peak boost.

Board

Arduino Uno R3

Parts

0.5 to 4.5 V pressure sender, pressure sensor, resistor, push button, buzzer, +2 more

Level

Intermediate

Open in the simulator

### Pressure tank monitor

A pressure transducer and a pump relay run a 40/60 or 30/50 psi cut-in and cut-out, count pump cycles and run time, and flag short cycling.

Board

Arduino Uno R3

Parts

0.5 to 4.5 V pressure sender, relay module, filament lamp, slide switch, push button, +2 more

Level

Advanced

Open in the simulator

### Deep-sea dive computer

A pressure transducer turned into depth (about 1 atm per 10 m of sea water), a DS18B20 water probe.

Board

Arduino Uno R3

Parts

0.5 to 4.5 V pressure sender, DS18B20 temperature sensor, resistor, SSD1306 OLED display, piezo speaker

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The 0.5 to 4.5 V pressure sender part page Every project ideas list

### Library pages

- LiquidCrystal I2C library
- Adafruit GFX library
- Adafruit SSD1306 library
- DallasTemperature library
- OneWire library

### More project ideas

- Arduino Uno project ideas
- LED projects for Arduino, ESP32 and Pico
- Projects with a push button
- Projects with a buzzer
- Projects with a DS18B20 sensor
- Projects with a lamp
- Projects with an I2C LCD
- Projects with a 20x4 I2C LCD
