Source: https://mokxi.com/ideas/pico-beginner
Updated: 2026-11-17

Projects / Project ideas
Pico for beginners

# Raspberry Pi Pico projects for beginners

These are the beginner projects on a Pico or Pico W, many in MicroPython, with blink, buttons, knobs, buzzers, NeoPixels and a first sensor. There are 65. Here are 24, from “Pico button” to “CircuitPython BME280 on a Pico”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “CircuitPython BME280 on a Pico”, a beginner project that needs a BME280 sensor.
- All of them run on a Raspberry Pi Pico, so that is the one board you need.
- The parts used most here are the LED (18 projects), the push button (8) and the potentiometer (5). With those on hand, most of this list is open to you.
- MicroPython runs a line at a time, so a mistake shows the line it is on. Read the error, fix that line and press Run again.

Projects

## 24 projects of 65

### Pico button

A button on GP15 with the internal pull-up lights the LED on GP25.

Board

Raspberry Pi Pico

Parts

Push button, resistor, LED

Level

Beginner

Open in the simulator

### RP2040-Zero NeoPixel

The Waveshare RP2040-Zero fades its own NeoPixel on GP16 around the color wheel.

Board

Waveshare RP2040-Zero

Parts

Just the board

Level

Beginner

Open in the simulator

### MicroPython WiFi station mode on a Pico W

MicroPython on a Raspberry Pi Pico W: network.WLAN joins Mokxi’s simulated access point and prints the IP address, mask and gateway it was given.

Board

Raspberry Pi Pico W

Parts

Just the board

Level

Beginner

Open in the simulator

### XIAO RP2040 blink

The red user LED of the XIAO RP2040, on GPIO 17, which lights when the pin is LOW.

Board

Seeed XIAO RP2040

Parts

Just the board

Level

Beginner

Open in the simulator

### CircuitPython OLED text on a Pico

CircuitPython on a Raspberry Pi Pico: displayio and Adafruit’s display_text draw a title and a counter on an SSD1306 OLED over I2C.

Board

Raspberry Pi Pico

Parts

SSD1306 OLED display

Level

Beginner

Open in the simulator

### Nano RP2040 button

A pushbutton on D2 of the Nano RP2040 Connect lights the LED on D13, with the RP2040’s own pull-up and the Nano’s pin names.

Board

Arduino Nano RP2040 Connect

Parts

Push button

Level

Beginner

Open in the simulator

### Stop the light game

Stop the light game on a Raspberry Pi Pico: press the button as a red light runs onto the green LED of a 16-LED NeoPixel ring, faster every level.

Board

Raspberry Pi Pico

Parts

WS2812 NeoPixel LEDs, arcade button, piezo speaker

Level

Beginner

Open in the simulator

### Pico W micro switch on GP14

MicroPython on a Pico W: a lever micro switch with its common on GP14 reads 1 while pressed and 0 at rest, and prints each change.

Board

Raspberry Pi Pico W

Parts

Limit switch, resistor, capacitor

Level

Beginner

Open in the simulator

### HC-SR04 on a Pico with MicroPython

MicroPython on a Raspberry Pi Pico: machine.time_pulse_us() times an HC-SR04’s echo, divided down to 3.3 V, and prints the distance twice a second.

Board

Raspberry Pi Pico

Parts

HC-SR04 ultrasonic sensor, resistor

Level

Beginner

Open in the simulator

### RP2040-Zero blink

An LED on GP0 of the RP2040-Zero, which has no plain LED of its own, with the board beside the breadboard.

Board

Waveshare RP2040-Zero

Parts

Resistor, LED

Level

Beginner

Open in the simulator

### MicroPython WiFi access point mode on a Pico W

MicroPython on a Raspberry Pi Pico W: network.WLAN(AP_IF) starts the board’s own access point and prints its name and IP settings.

Board

Raspberry Pi Pico W

Parts

Just the board

Level

Beginner

Open in the simulator

### DHT11 on a Pico with MicroPython

MicroPython’s built-in dht module on a Raspberry Pi Pico: a DHT11 on GP15 prints the temperature and humidity every two seconds.

Board

Raspberry Pi Pico

Parts

DHT11 or DHT22 sensor

Level

Beginner

Open in the simulator

### XIAO RP2040 NeoPixel

The XIAO RP2040 powers its own NeoPixel from GPIO 11 and fades it around the color wheel on GPIO 12.

Board

Seeed XIAO RP2040

Parts

Just the board

Level

Beginner

Open in the simulator

### CircuitPython button on a Pico

CircuitPython on a Raspberry Pi Pico: a button on GP14 with the pin’s pull-up lights the board’s LED while it is held and counts each press.

Board

Raspberry Pi Pico

Parts

Push button

Level

Beginner

Open in the simulator

### Pico W active buzzer beeps through an S8050

MicroPython on a Pico W: GP15 switches an S8050 that sounds an active buzzer: four short beeps, a pause of a second, and again.

Board

Raspberry Pi Pico W

Parts

Buzzer, transistor, resistor

Level

Beginner

Open in the simulator

### MicroPython servo sweep on a Pico, signal on GP16

MicroPython on a Raspberry Pi Pico: 50 Hz PWM on GP16 sweeps a servo from 0 to 180 degrees and back, one degree every 15 ms.

Board

Raspberry Pi Pico

Parts

Servo motor

Level

Beginner

Open in the simulator

### CircuitPython blink on a Pico

CircuitPython on a Raspberry Pi Pico: digitalio blinks the board’s own LED and a red LED on GP15, once a second, and print() says on and off.

Board

Raspberry Pi Pico

Parts

Resistor, LED

Level

Beginner

Open in the simulator

### Pico W water pump on a motor driver

MicroPython on a Pico W: GP14 high and GP15 low keep a small DC water pump running through a two-input motor driver.

Board

Raspberry Pi Pico W

Parts

L9110S motor driver, mini water pump

Level

Beginner

Open in the simulator

### MicroPython on a Pico: read a potentiometer on GP26

MicroPython on a Raspberry Pi Pico: machine.ADC reads a potentiometer’s wiper on GP26 and prints the reading and its voltage ten times a second.

Board

Raspberry Pi Pico

Parts

Potentiometer

Level

Beginner

Open in the simulator

### Pico W button on GP14 with a pull-down

MicroPython on a Pico W: a push button from 3.3 V to GP14, held low by a 10k pull-down, prints a line to the Serial Monitor at each press.

Board

Raspberry Pi Pico W

Parts

Push button, resistor

Level

Beginner

Open in the simulator

### CircuitPython NeoPixel rainbow on a Pico

CircuitPython on a Raspberry Pi Pico: Adafruit’s neopixel library turns a rainbow around eight WS2812 LEDs on GP16, sent by the Pico’s PIO.

Board

Raspberry Pi Pico

Parts

WS2812 NeoPixel LEDs

Level

Beginner

Open in the simulator

### MicroPython on a Pico: import a module of your own

MicroPython on a Raspberry Pi Pico: main.py imports helpers.py from the next tab and prints a random number from it once a second.

Board

Raspberry Pi Pico

Parts

Just the board

Level

Beginner

Open in the simulator

### Pico W slide switch on GP14

MicroPython on a Pico W: a slide switch puts GP14 on 3.3 V or on ground, with a 10k and a 100 nF to steady it, and the program prints each side.

Board

Raspberry Pi Pico W

Parts

Slide switch, resistor, capacitor

Level

Beginner

Open in the simulator

### CircuitPython BME280 on a Pico

CircuitPython on a Raspberry Pi Pico: busio.I2C and Adafruit’s adafruit_bme280 read the temperature.

Board

Raspberry Pi Pico

Parts

BME280 weather sensor

Level

Beginner

Open in the simulator

See all 65 beginner projects on the templates page

Keep going

## Wiring, libraries and more ideas

Every project ideas list

### Wiring guides

- LED to Raspberry Pi Pico
- push button to Raspberry Pi Pico
- potentiometer to Raspberry Pi Pico
- WS2812 LED strip to Raspberry Pi Pico
- DHT22 to Raspberry Pi Pico
- RGB LED to Raspberry Pi Pico
- servo to Raspberry Pi Pico
- buzzer to Raspberry Pi Pico

### Library pages

- Adafruit NeoPixel library

### More project ideas

- Raspberry Pi Pico project ideas
- LED projects for Arduino, ESP32 and Pico
- Projects with a push button
- Projects with a potentiometer
- NeoPixel projects
- Projects with a transistor
- Projects with a DHT11 or DHT22 sensor
- Projects with an RGB LED
- Servo motor projects
- Arduino game projects
- Home automation projects with ESP32 and Arduino
- IoT project ideas for ESP32 and Pico W
