Source: https://mokxi.com/ideas/mpu6050-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with an MPU6050

18 Mokxi projects use an MPU6050 accelerometer and gyro (1 beginner, 8 intermediate and 9 advanced). They run on Arduino Uno, Raspberry Pi Pico and ESP32 boards. Here are all of them, from “MPU-6050 readings over I2C” to “Tilt sand”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “MPU-6050 readings over I2C”, a beginner project that needs an MPU6050.
- Arduino Uno runs 12 of them, Raspberry Pi Pico 3 and ESP32 2. Start on the board you have, or on an Arduino Uno if you are buying one.
- The parts used most here are the LED (6 projects), the push button (5) and the servo motor (4). With those on hand, most of this list is open to you.
- Before you build one on a real bench, read the MPU6050 accelerometer and gyro wiring guide for your board below. It gives every pin and the voltage notes.

Projects

## 18 projects ready to run

### MPU-6050 readings over I2C

A GY-521 board with an MPU-6050 on A4 and A5: the sketch wakes the chip and prints its raw accelerometer.

Board

Arduino Uno R3

Parts

MPU6050 accelerometer and gyro

Level

Beginner

Open in the simulator

### MicroPython MPU6050 accelerometer and gyroscope

MicroPython on an ESP32: machine.I2C on GPIO 14 and 13 reads an MPU6050’s acceleration and rotation, raw and in g and degrees per second.

Board

ESP32-DevKitC V4

Parts

MPU6050 accelerometer and gyro

Level

Intermediate

Open in the simulator

### Tilt meter

An MPU6050 over I2C and three lamps. Drag the board to tip it: the accelerometer reads gravity, and the gyroscope reads how fast you moved.

Board

Arduino Uno R3

Parts

MPU6050 accelerometer and gyro, resistor, LED

Level

Intermediate

Open in the simulator

### Kalman filter tilt angle with an MPU6050

An MPU6050’s accelerometer and gyro fused by a Kalman filter into roll and pitch, plotted beside the raw angles, with a level LED.

Board

Arduino Uno R3

Parts

Resistor, LED, MPU6050 accelerometer and gyro

Level

Intermediate

Open in the simulator

### MicroPython MPU6050 on a Pico: acceleration and rotation

MicroPython on a Raspberry Pi Pico: an MPU6050 on I2C bus 1 (SCL GP15, SDA GP14) prints raw and scaled acceleration and rotation once a second.

Board

Raspberry Pi Pico

Parts

MPU6050 accelerometer and gyro

Level

Intermediate

Open in the simulator

### Pico W MPU6050 acceleration and rotation

MicroPython on a Pico W: an MPU6050 on I2C1 (SDA GP6, SCL GP7) prints its acceleration in g and its rotation in degrees a second.

Board

Raspberry Pi Pico W

Parts

MPU6050 accelerometer and gyro

Level

Intermediate

Open in the simulator

### Tilt snake on an 8x8 matrix

Tip an MPU-6050 on A4 and A5 to steer a snake round an 8x8 MAX7219 matrix (DIN 13, CLK 7, CS 8): eat the blinking dot to grow.

Board

Arduino Uno R3

Parts

MAX7219 8x8 LED matrix, MPU6050 accelerometer and gyro

Level

Intermediate

Open in the simulator

### Catch the beans: a tilt game on an 8x8 matrix

Tip an MPU-6050 to slide a cup along a MAX7219 matrix (DIN 13, CLK 7, CS 8) and catch the falling beans.

Board

Arduino Uno R3

Parts

RGB LED, resistor, MAX7219 8x8 LED matrix, MPU6050 accelerometer and gyro, piezo speaker

Level

Intermediate

Open in the simulator

### Torque angle meter

An MPU6050 gyro integrated into the angle a wrench turns a torque-to-yield bolt past snug, on a 16x2 I2C LCD with a target, a beeper that speeds up.

Board

Arduino Uno R3

Parts

MPU6050 accelerometer and gyro, push button, buzzer, resistor, LED, +1 more

Level

Intermediate

Open in the simulator

### Pico W tilt controller: MPU6050 points a servo

MicroPython on a Pico W: the tilt of an MPU6050 on I2C1, worked out from gravity and averaged, turns a servo on GP15 to follow it.

Board

Raspberry Pi Pico W

Parts

MPU6050 accelerometer and gyro, servo motor

Level

Advanced

Open in the simulator

### MPU6050 servo stabilizer

A self-leveling gimbal on an Uno: tilt the MPU6050 and two servos turn the other way to hold a platform level, through a complementary filter.

Board

Arduino Uno R3

Parts

Servo motor, MPU6050 accelerometer and gyro

Level

Advanced

Open in the simulator

### Escape-room puzzle box

Five puzzles in ten minutes: a keypad code, a magnet key, the right RFID card, a tilt sequence and three flashes of light.

Board

Arduino Mega 2560 R3

Parts

4x4 keypad, reed switch, piezo speaker, MPU6050 accelerometer and gyro, servo motor, +6 more

Level

Advanced

Open in the simulator

### Seismograph

An MPU6050 with gravity filtered out and a SW-420 vibration switch.

Board

Arduino Uno R3

Parts

MPU6050 accelerometer and gyro, vibration sensor, SSD1306 OLED display

Level

Advanced

Open in the simulator

### Desk buddy robot

Animated robot eyes on a round GC9A01: it blinks and glances about, beams when you stroke it, gets dizzy when rocked and lonely when ignored.

Board

ESP32-C3-DevKitM-1

Parts

GC9A01 round display, MPU6050 accelerometer and gyro, touch sensor, photoresistor module, piezo speaker

Level

Advanced

Open in the simulator

### Rocket flight computer

A model rocket flight computer: launch, burnout and a filtered apogee that fires the parachute servo, with a self-test.

Board

Arduino Uno R3

Parts

MicroSD card module, servo motor, pressure and temperature, MPU6050 accelerometer and gyro, push button, +3 more

Level

Advanced

Open in the simulator

### Laser sword

A light saber style sword on an Uno: a WS2812 blade that ignites and retracts, swing and clash from an MPU6050.

Board

Arduino Uno R3

Parts

WS2812 NeoPixel LEDs, MPU6050 accelerometer and gyro, resistor, LED, push button, +3 more

Level

Advanced

Open in the simulator

### Hand gesture controlled car

Tilt an MPU6050 on your hand and a 2WD car follows over nRF24L01 radios: forward, reverse, left, right, and it stops when the signal is lost.

Board

Arduino Uno R3

Parts

NRF24L01+ 2.4 GHz radio, MPU6050 accelerometer and gyro, L298N motor driver, 2WD robot car chassis

Level

Advanced

Open in the simulator

### Tilt sand

A tray of glowing sand on a 16x8 LED matrix: tip an MPU6050 and the grains pour downhill, pile against the edge and settle.

Board

Arduino Uno R3

Parts

WS2812 NeoPixel LEDs, MPU6050 accelerometer and gyro, resistor, push button

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The MPU6050 accelerometer and gyro part page Every project ideas list

### Wiring guides

- MPU6050 to Arduino Uno
- MPU6050 to Arduino Mega
- MPU6050 to Raspberry Pi Pico
- MPU6050 to Arduino Nano
- MPU6050 to ESP32

### Library pages

- Adafruit MPU6050 library
- GY521 library
- Madgwick library
- MPU6050 library
- MPU6050_light library
- MPU6050_tockn library

### More project ideas

- Arduino Uno project ideas
- Raspberry Pi Pico project ideas
- ESP32 project ideas
- Arduino Mega project ideas
- LED projects for Arduino, ESP32 and Pico
- Projects with a push button
- Servo motor projects
- Projects with a piezo speaker
- Projects with a buzzer
- Projects with a light sensor module
- Projects with a MAX7219 LED matrix
