Source: https://mokxi.com/ideas/lm358-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with an LM358 op-amp

4 Mokxi projects use an LM358 op-amp (2 beginner and 2 intermediate). They run on Arduino Uno boards, and 3 need no board at all. Here are all of them, from “741 vs LM358 on 5 V” to “LM358 amplifier on a scope”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “741 vs LM358 on 5 V”, a beginner project that needs an LM358 op-amp, an LM741 op-amp (uA741), a potentiometer and 1 more part.
- Arduino Uno runs 1 of them and 3 need no board at all. Start on the board you have, or on an Arduino Uno if you are buying one.
- The parts used most here are the potentiometer (3 projects), the photoresistor (1) and the LED (1). With those on hand, most of this list is open to you.
- Before you build one on a real bench, open the LM358 dual op-amp part page for its pins and what each one does.

Projects

## 4 projects ready to run

### 741 vs LM358 on 5 V

A 741 and an LM358 follow the same knob on a 5 V supply: the LM358 goes from 0 to 3.5 V, the 741 never leaves 1.5 to 3.5 V.

Board

No board

Parts

LM358 dual op-amp, LM741 op-amp (uA741), potentiometer, multimeter

Level

Beginner

Open in the simulator

### Rail-to-rail op-amps on 3.3 V

An LM358, an MCP6002, an LMV358 and an MCP6004 follow one knob on 3.3 V.

Board

No board

Parts

Potentiometer, LM358 dual op-amp, multimeter, MCP6002 dual rail-to-rail op-amp, LMV358 dual rail-to-rail op-amp, +1 more

Level

Beginner

Open in the simulator

### LM358 dark switch with an Arduino

An LM358 comparator lights an LED when the LDR goes dark, past a threshold set by a knob.

Board

Arduino Uno R3

Parts

Photoresistor, resistor, potentiometer, LM358 dual op-amp, LED

Level

Intermediate

Open in the simulator

### LM358 amplifier on a scope

An LM358 non-inverting amplifier with a gain of 3.2 on one 5 V supply: a 0.2 to 1.0 V sine in, 0.64 to 3.20 V out, and a clip at 3.5 V to find.

Board

No board

Parts

Function generator, LM358 dual op-amp, resistor, oscilloscope

Level

Intermediate

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The LM358 dual op-amp part page Every project ideas list

### More project ideas

- Electronics projects with no code
- Arduino Uno project ideas
- Projects with a potentiometer
- Projects with a photoresistor
- LED projects for Arduino, ESP32 and Pico
