Source: https://mokxi.com/ideas/l298n-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with an L298N motor driver

9 Mokxi projects use an L298N motor driver (2 beginner, 4 intermediate and 3 advanced). They run on Arduino Uno boards. Here are all of them, from “Linear actuator out and back” to “Hand gesture controlled car”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Linear actuator out and back”, a beginner project that needs an L298N motor driver and a linear actuator.
- All of them run on an Arduino Uno, so that is the one board you need.
- The parts used most here are the 2WD robot car chassis (7 projects), the photoresistor module (2) and the servo motor (2). With those on hand, most of this list is open to you.
- Before you build one on a real bench, read the L298N motor driver wiring guide for your board below. It gives every pin and the voltage notes.

Projects

## 9 projects ready to run

### Linear actuator out and back

A 12 V linear actuator on an L298N from pins 8 and 9 runs out for 12 s and back for 12 s. Its own limit switches stop it at each end.

Board

Arduino Uno R3

Parts

L298N motor driver, linear actuator

Level

Beginner

Open in the simulator

### Light-seeking robot

A two-wheel robot with a photoresistor module on each front corner.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, photoresistor module

Level

Beginner

Open in the simulator

### Obstacle-avoiding car

A 2WD robot car on an L298N with an HC-SR04 on the front. It drives ahead, and when something comes within 25 cm it backs up, turns and carries on.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, HC-SR04 ultrasonic sensor

Level

Intermediate

Open in the simulator

### Joystick robot car with an L298N

A thumb stick on A1 and A2 drives a 2WD car on an L298N like a tank: throttle plus steer on one wheel, minus on the other, and a press for slow mode.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, joystick

Level

Intermediate

Open in the simulator

### Robot car drive

Two gearbox motors on an L298N module from six Uno pins: forward, a turn, a spin on the spot and reverse, with the speed on ENA and ENB.

Board

Arduino Uno R3

Parts

L298N motor driver, DC motor

Level

Intermediate

Open in the simulator

### Bluetooth RC car with an HC-05

An HC-05 and a 2WD car on an L298N: type F, B, L, R or S in the module’s box, as a phone app sends them, and the car drives; 0 to 9 set the speed.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, HC-05 Bluetooth module, resistor

Level

Intermediate

Open in the simulator

### Fire fighting robot

Three flame sensors steer a 2WD car on an L298N to the fire, then a relay runs a water pump while a servo sweeps the nozzle until the flame is out.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, flame sensor, servo motor, relay module, +1 more

Level

Advanced

Open in the simulator

### Mars rover

A rover that drives three waypoints by dead reckoning, steers around hazards it sees with a sonar mast, samples soil and light.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, push button, SSD1306 OLED display, VL53L0X time-of-flight sensor, +3 more

Level

Advanced

Open in the simulator

### Hand gesture controlled car

Tilt an MPU6050 on your hand and a 2WD car follows over nRF24L01 radios: forward, reverse, left, right, and it stops when the signal is lost.

Board

Arduino Uno R3

Parts

NRF24L01+ 2.4 GHz radio, MPU6050 accelerometer and gyro, L298N motor driver, 2WD robot car chassis

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The L298N motor driver part page Every project ideas list

### Wiring guides

- L298N motor driver to Arduino Uno
- L298N motor driver to Arduino Mega
- L298N motor driver to Arduino Nano
- L298N motor driver to Raspberry Pi Pico

### Library pages

- L298N library
- Servo library
- Adafruit GFX library
- Adafruit MPU6050 library
- Adafruit SSD1306 library
- Adafruit Unified Sensor library

### More project ideas

- Arduino Uno project ideas
- Projects with a robot car chassis
- Projects with a light sensor module
- Servo motor projects
- Projects with a DC motor
- Projects with an HC-05 Bluetooth module
- Projects with an ultrasonic sensor
