Source: https://mokxi.com/ideas/ina219-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with an INA219 current sensor

6 Mokxi projects use an INA219 current sensor (4 intermediate and 2 advanced). They run on Arduino Uno and ESP32 boards. Here are all of them, from “Current and voltage” to “Bench supply monitor”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Current and voltage”, an intermediate project that needs a resistor, a sixteen-bit ADC and an INA219 current sensor.
- Arduino Uno runs 5 of them and ESP32 1. Start on the board you have, or on an Arduino Uno if you are buying one.
- The parts used most here are the push button (4 projects), the LED (3) and the I2C LCD (2). With those on hand, most of this list is open to you.
- Before you build one on a real bench, open the INA219 current monitor part page for its pins and what each one does.

Projects

## 6 projects ready to run

### Current and voltage

An INA219 in series with a 220 ohm load and an ADS1115 on the same node, both on I2C: milliamps through a real shunt.

Board

ESP32-C3-DevKitM-1

Parts

Resistor, sixteen-bit ADC, INA219 current monitor

Level

Intermediate

Open in the simulator

### Turn signals and hazard flasher

Left, right and hazard buttons flash two 12 V bulbs a side through a relay board at 90 a minute.

Board

Arduino Uno R3

Parts

Push button, resistor, LED, two-channel relay board, INA219 current monitor, +3 more

Level

Intermediate

Open in the simulator

### Bunker battery gauge

An INA219 measures a battery under load.

Board

Arduino Uno R3

Parts

Battery: AA, INA219 current monitor, resistor, piezo speaker, traffic light module

Level

Intermediate

Open in the simulator

### Voltage drop calculator

Pick a wire gauge, a run length and a load current: the Uno computes the round-trip voltage drop, flags 3% and 5% (NEC recommendations.

Board

Arduino Uno R3

Parts

Potentiometer, push button, INA219 current monitor, resistor, I2C LCD

Level

Intermediate

Open in the simulator

### Solar tracker

Four light sensors steer a pan and tilt servo pair, an INA219 measures the panel, and the sketch alternates tracked and fixed windows.

Board

Arduino Uno R3

Parts

Photoresistor, resistor, servo motor, INA219 current monitor, solar panel, +2 more

Level

Advanced

Open in the simulator

### Bench supply monitor

An INA219 reads a 12 V supply’s volts, amps, watts and watt-hours on an LCD; an over-current knob trips a shutoff relay that latches, with a buzzer.

Board

Arduino Uno R3

Parts

INA219 current monitor, DC voltage source, relay module, resistor, slide switch, +5 more

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The INA219 current monitor part page Every project ideas list

### Library pages

- Adafruit INA219 library
- LiquidCrystal I2C library
- Adafruit ADS1X15 library
- Servo library

### More project ideas

- Arduino Uno project ideas
- ESP32 project ideas
- Projects with a push button
- LED projects for Arduino, ESP32 and Pico
- Projects with an I2C LCD
- Projects with a potentiometer
- Projects with a slide switch
- Projects with a buzzer
