Source: https://mokxi.com/ideas/chassis2wd-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with a robot car chassis

14 Mokxi projects use a 2WD robot car chassis (1 beginner, 9 intermediate and 4 advanced). They run on Arduino Uno boards. Here are all of them, from “Light-seeking robot” to “Hand gesture controlled car”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Light-seeking robot”, a beginner project that needs an L298N motor driver, a robot car chassis and a light sensor module.
- All of them run on an Arduino Uno, so that is the one board you need.
- The parts used most here are the L298N motor driver (7 projects), the DRV8833 motor driver (4) and the HC-SR04 ultrasonic sensor (3). With those on hand, most of this list is open to you.
- Before you build one on a real bench, open the 2WD robot car chassis part page for its pins and what each one does.

Projects

## 14 projects ready to run

### Light-seeking robot

A two-wheel robot with a photoresistor module on each front corner.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, photoresistor module

Level

Beginner

Open in the simulator

### Joystick robot car with an L298N

A thumb stick on A1 and A2 drives a 2WD car on an L298N like a tank: throttle plus steer on one wheel, minus on the other, and a press for slow mode.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, joystick

Level

Intermediate

Open in the simulator

### Obstacle-avoiding car

A 2WD robot car on an L298N with an HC-SR04 on the front. It drives ahead, and when something comes within 25 cm it backs up, turns and carries on.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, HC-SR04 ultrasonic sensor

Level

Intermediate

Open in the simulator

### Bumper car

A 2WD robot car on a DRV8833 with two lever microswitches for bumpers. It drives until a bumper is hit, then backs off and turns away from that side.

Board

Arduino Uno R3

Parts

DRV8833 motor driver, 2WD robot car chassis, limit switch

Level

Intermediate

Open in the simulator

### Maze-solving robot

A two-wheel robot with three Sharp infrared distance sensors.

Board

Arduino Uno R3

Parts

DRV8833 motor driver, 2WD robot car chassis, IR distance sensor

Level

Intermediate

Open in the simulator

### Bluetooth RC car with an HC-05

An HC-05 and a 2WD car on an L298N: type F, B, L, R or S in the module’s box, as a phone app sends them, and the car drives; 0 to 9 set the speed.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, HC-05 Bluetooth module, resistor

Level

Intermediate

Open in the simulator

### Infrared remote rover

A two-wheel robot driven from a 21-button infrared remote.

Board

Arduino Uno R3

Parts

MX1508 dual motor driver, 2WD robot car chassis, IR receiver and remote, IR remote

Level

Intermediate

Open in the simulator

### Scanning obstacle rover

A robot with an ultrasonic sensor on a servo neck. Blocked, it stops, looks right, ahead and left, picks the clearest way and turns that way.

Board

Arduino Uno R3

Parts

TB6612FNG motor driver, 2WD robot car chassis, servo motor, HC-SR04 ultrasonic sensor

Level

Intermediate

Open in the simulator

### Robot vacuum behaviors

A cleaning robot with two bumpers and a cliff sensor.

Board

Arduino Uno R3

Parts

DRV8833 motor driver, 2WD robot car chassis, limit switch, TCRT5000 line sensor

Level

Intermediate

Open in the simulator

### Sumo robot

A mini-sumo robot with an ultrasonic eye and two edge sensors.

Board

Arduino Uno R3

Parts

DRV8833 motor driver, 2WD robot car chassis, HC-SR04 ultrasonic sensor, TCRT5000 line sensor

Level

Intermediate

Open in the simulator

### Wheel-encoder square driver

A two-wheel robot that counts pulses from a slot sensor on each wheel.

Board

Arduino Uno R3

Parts

L9110S motor driver, 2WD robot car chassis

Level

Advanced

Open in the simulator

### Mars rover

A rover that drives three waypoints by dead reckoning, steers around hazards it sees with a sonar mast, samples soil and light.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, push button, SSD1306 OLED display, VL53L0X time-of-flight sensor, +3 more

Level

Advanced

Open in the simulator

### Fire fighting robot

Three flame sensors steer a 2WD car on an L298N to the fire, then a relay runs a water pump while a servo sweeps the nozzle until the flame is out.

Board

Arduino Uno R3

Parts

L298N motor driver, 2WD robot car chassis, flame sensor, servo motor, relay module, +1 more

Level

Advanced

Open in the simulator

### Hand gesture controlled car

Tilt an MPU6050 on your hand and a 2WD car follows over nRF24L01 radios: forward, reverse, left, right, and it stops when the signal is lost.

Board

Arduino Uno R3

Parts

NRF24L01+ 2.4 GHz radio, MPU6050 accelerometer and gyro, L298N motor driver, 2WD robot car chassis

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The 2WD robot car chassis part page Every project ideas list

### Library pages

- Servo library
- Adafruit GFX library
- Adafruit MPU6050 library
- Adafruit SSD1306 library
- Adafruit Unified Sensor library
- IRremote library

### More project ideas

- Arduino Uno project ideas
- Projects with an L298N motor driver
- Projects with a DRV8833 motor driver
- Projects with an ultrasonic sensor
- Servo motor projects
- Projects with a light sensor module
- Projects with a limit switch
- Projects with a TCRT5000 line sensor
