Source: https://mokxi.com/ideas/capacitor-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with a capacitor

29 Mokxi projects use a capacitor (13 beginner, 13 intermediate and 3 advanced). They run on Arduino Uno and Raspberry Pi Pico boards, and 20 need no board at all. Here are 24, from “Pico W micro switch on GP14” to “Op-amp low pass on the bench”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Operating point and sweep”, a beginner project that needs a resistor and a capacitor.
- Arduino Uno runs 4 of them, Raspberry Pi Pico 3 and 20 need no board at all. Start on the board you have, or on an Arduino Uno if you are buying one.
- The parts used most here are the LED (11 projects), the NE555 timer (7) and the slide switch (5). With those on hand, most of this list is open to you.
- Before you build one on a real bench, open the capacitor part page for its pins and what each one does.

Projects

## 24 projects of 29

### Pico W micro switch on GP14

MicroPython on a Pico W: a lever micro switch with its common on GP14 reads 1 while pressed and 0 at rest, and prints each change.

Board

Raspberry Pi Pico W

Parts

Limit switch, resistor, capacitor

Level

Beginner

Open in the simulator

### Operating point and sweep

A 10 k divider and a 10 k / 10 uF RC on one board, for reading every node at once and sweeping the supply or a resistor.

Board

No board

Parts

Resistor, capacitor

Level

Beginner

Open in the simulator

### Pico W slide switch on GP14

MicroPython on a Pico W: a slide switch puts GP14 on 3.3 V or on ground, with a 10k and a 100 nF to steady it, and the program prints each side.

Board

Raspberry Pi Pico W

Parts

Slide switch, resistor, capacitor

Level

Beginner

Open in the simulator

### RC filter on the bench

A function generator into an RC low pass, with a two-channel scope on both ends and a multimeter reading the output.

Board

No board

Parts

Function generator, resistor, capacitor, oscilloscope, multimeter

Level

Beginner

Open in the simulator

### NE556 two blinkers

The two 555 timers in one NE556, each an astable with its own LED: 1.5 Hz and 3.2 Hz from one chip on one 5 V supply.

Board

No board

Parts

NE556 dual timer, resistor, capacitor, LED

Level

Beginner

Open in the simulator

### The rest of the dial

A board with no power on it and one meter: diode, ohms, capacitance and continuity, the four positions that only mean anything with the supply off.

Board

No board

Parts

LED, capacitor, resistor, multimeter

Level

Beginner

Open in the simulator

### A logic probe

A 555 clock with a logic probe on its output and another on a column nothing is driving: pulsing, and the floating input a voltmeter cannot find.

Board

No board

Parts

Resistor, NE555 timer, capacitor, logic probe

Level

Beginner

Open in the simulator

### TLC555 blinker on 3.3 V

The 555 blinker, wire for wire, on a 3.3 V supply with a TLC555: the CMOS 555 runs from 2 V where an NE555 will not start, at the same 1.4 or 7.4 Hz.

Board

No board

Parts

Resistor, TLC555 CMOS timer, slide switch, capacitor, LED

Level

Beginner

Open in the simulator

### 7805 voltage regulator circuit

A 9 V battery into a 7805 with its 0.33 uF and 0.1 uF capacitors: 5 V out to an LED, until the battery sags below about 6.7 V.

Board

No board

Parts

Battery: AA, voltage regulator, capacitor, resistor, LED

Level

Beginner

Open in the simulator

### Doorbell

A pushbutton lifts the 555 out of reset and a 4 Hz astable beeps the buzzer.

Board

No board

Parts

Resistor, NE555 timer, capacitor, push button, buzzer

Level

Beginner

Open in the simulator

### Breathing LED

One PWM pin, two LEDs: one sees the raw 1 kHz chopping, the other an RC filter smoothing it.

Board

ESP32-C3-DevKitM-1

Parts

Resistor, LED, capacitor

Level

Intermediate

Open in the simulator

### RS-232 loopback

The Uno’s TX goes out through a MAX232 at RS-232 levels, round a loopback jumper and back in on pin 8, the way a COM port is tested.

Board

Arduino Uno R3

Parts

RS-232 transceiver, capacitor

Level

Intermediate

Open in the simulator

### 555 on the bench

A 555 astable with a scope on its output and its timing capacitor and a multimeter reading the average: the frequency.

Board

No board

Parts

Resistor, NE555 timer, capacitor, oscilloscope, multimeter

Level

Intermediate

Open in the simulator

### Decade chaser

A 555 astable clocks a CD4017 decade counter and ten LEDs take turns to light, with no microcontroller.

Board

No board

Parts

NE555 timer, resistor, capacitor, CD4017 decade counter, LED

Level

Intermediate

Open in the simulator

### Automatic curtain opener with a stepper motor

A NEMA 17 on an A4988 homes to an end switch, opens the curtain at dawn and closes it at dusk, with a button to open, close or stop and a speed knob.

Board

Arduino Uno R3

Parts

A4988 stepper driver, NEMA 17 stepper motor, DC jack and adapter, capacitor, limit switch, +4 more

Level

Intermediate

Open in the simulator

### LM386 speaker amp

An Uno plays a tune with tone() on pin 8, and an LM386 with a gain of 20 drives an 8 ohm speaker from a 9 V battery.

Board

Arduino Uno R3

Parts

Battery: AA, LM386 audio amplifier, resistor, capacitor, 8 ohm speaker

Level

Intermediate

Open in the simulator

### Mains to 17 V DC

A 230 V to 12-0-12 V mains transformer, two 1N4007s as a full-wave rectifier and 1000 uF of smoothing.

Board

No board

Parts

Signal generator, mains transformer, diode, capacitor, resistor, +2 more

Level

Intermediate

Open in the simulator

### Waveform lab

PWM audio on an Uno: Timer 1 and an RC filter turn pulse widths into a sine, triangle, sawtooth or square wave on a scope.

Board

Arduino Uno R3

Parts

Resistor, capacitor, push button, potentiometer, piezo speaker, +1 more

Level

Intermediate

Open in the simulator

### CD4060 timer

A CD4060 oscillates on two resistors and a capacitor and divides it down to blink four LEDs, each at half the rate of the one before.

Board

No board

Parts

CD4060 counter with oscillator, resistor, capacitor, LED

Level

Intermediate

Open in the simulator

### Pico W alarm siren and lamp on a slide switch

MicroPython on a Pico W: a slide switch on GP17 turns on a siren, a passive buzzer on GP15 sweeping 130 to 800 Hz with an LED on GP16 pulsing in step.

Board

Raspberry Pi Pico W

Parts

Piezo speaker, transistor, resistor, slide switch, capacitor, +1 more

Level

Intermediate

Open in the simulator

### Counting a 555

A 555 astable with a frequency counter and a multimeter on its Hz range: frequency, period, duty and a running pulse total, against the arithmetic.

Board

No board

Parts

Resistor, NE555 timer, capacitor, frequency counter, multimeter

Level

Intermediate

Open in the simulator

### Eurorack CV quantizer

A control voltage snapped to the nearest note of a scale and sent out at one volt per octave through a filtered PWM DAC.

Board

Arduino Nano

Parts

Potentiometer, resistor, capacitor, LED, slide switch, +2 more

Level

Advanced

Open in the simulator

### Decoder chaser

A 74HC14 oscillator clocks a 74HC161 counter and a 74HC138 decoder lights one LED of eight at a time.

Board

No board

Parts

74HC14 Schmitt inverter, resistor, capacitor, 74HC161 4-bit counter, 74HC138 3-to-8 decoder, +1 more

Level

Advanced

Open in the simulator

### Op-amp low pass on the bench

A signal generator into an inverting op-amp low pass biased off a single 5 V rail, with a scope on the output: a real gain in the pass band.

Board

No board

Parts

Function generator, resistor, capacitor, op-amp, oscilloscope

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The capacitor part page Every project ideas list

### Library pages

- FastAccelStepper library

### More project ideas

- Electronics projects with no code
- Arduino Uno project ideas
- Raspberry Pi Pico project ideas
- Arduino Nano project ideas
- LED projects for Arduino, ESP32 and Pico
- Projects with a 555 timer
- Projects with a slide switch
- Projects with a push button
- Projects with a piezo speaker
- Projects with a potentiometer
- Projects with a limit switch
