Source: https://mokxi.com/ideas/acs712-projects
Updated: 2026-11-17

Projects / Project ideas
Project ideas by part

# Projects with an ACS712 current sensor

6 Mokxi projects use an ACS712 current sensor (1 beginner, 4 intermediate and 1 advanced). They run on Arduino Uno boards. Here are all of them, from “Motor current meter” to “Motor starter”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

## How to pick your first one

- Start with “Motor current meter”, a beginner project that needs an ACS712 current sensor, a push button, a DC motor and 2 more parts.
- All of them run on an Arduino Uno, so that is the one board you need.
- The parts used most here are the push button (4 projects), the slide switch (4) and the LED (3). With those on hand, most of this list is open to you.
- Before you build one on a real bench, open the ACS712 current sensor part page for its pins and what each one does.

Projects

## 6 projects ready to run

### Motor current meter

An ACS712 in a 6 V gear motor’s lead and a 16x2 I2C LCD: the current now and the highest seen.

Board

Arduino Uno R3

Parts

ACS712 current sensor, push button, DC motor, bench power supply, I2C LCD

Level

Beginner

Open in the simulator

### Home energy monitor with EmonLib

A ZMPT101B and an ACS712 feed EmonLib on an Uno: volts, amps, real power and power factor on an I2C LCD, with the watt hours used adding up.

Board

Arduino Uno R3

Parts

AC voltage sensor, ACS712 current sensor, signal generator, slide switch, resistor, +1 more

Level

Intermediate

Open in the simulator

### Panel load monitor

Four ACS712 sensors on four breaker circuits, with low-voltage stand-in loads: OK, WARNING over 80% and OVERLOAD over 100% on RGB LEDs.

Board

Arduino Uno R3

Parts

LED, resistor, RGB LED, ACS712 current sensor, bench power supply

Level

Intermediate

Open in the simulator

### GFCI concept demo (not a real GFCI)

Two ACS712 sensors compare the hot and neutral current of a 12 V lamp and a relay latches open on a 60 mA imbalance: a teaching model.

Board

Arduino Uno R3

Parts

DC jack and adapter, ACS712 current sensor, relay module, filament lamp, resistor, +2 more

Level

Intermediate

Open in the simulator

### Sump pump controller

A teaching model of a sump controller: two floats run a relay pump, an ACS712 checks that current really flows, and alarms catch a dead pump.

Board

Arduino Uno R3

Parts

Float switch, ACS712 current sensor, relay module, mini water pump, slide switch, +4 more

Level

Intermediate

Open in the simulator

### Motor starter

START and a fail-safe STOP, a relay and a small DC motor, and an ACS712 that feeds an inverse-time overload trip with a manual RESET.

Board

Arduino Uno R3

Parts

Push button, resistor, LED, limit switch, ACS712 current sensor, +4 more

Level

Advanced

Open in the simulator

Keep going

## Wiring, libraries and more ideas

The ACS712 current sensor part page Every project ideas list

### Library pages

- ACS712 library
- EmonLib library
- LiquidCrystal I2C library

### More project ideas

- Arduino Uno project ideas
- Projects with a push button
- Projects with a slide switch
- LED projects for Arduino, ESP32 and Pico
- Projects with a relay module
- Projects with a DC motor
- Projects with an I2C LCD
- Projects with a buzzer
