Source: https://mokxi.com/boards/esp32-s3-cam
Updated: 2026-11-20

Board

# ESP32-S3-CAM simulator, the camera board on the ESP32-S3

The ESP32-S3-CAM is the common ESP32-S3 camera dev board: an ESP32-S3-WROOM-1 with 8 MB of PSRAM, an OV2640 camera socket, USB-C and a BOOT button, on forty-four header pins named by GPIO. Its user LED is on GPIO 48, and WiFi joins a simulated network. The camera is drawn but not simulated: esp_camera_init() fails and says so. A sketch can be as big as the Arduino IDE allows, 1,310,720 bytes, because it runs from flash as it does on the real board.

Start building free

- 6 peripheral areas modeled
- 1 project ready to run
- Real time on your own machine

Click to open it in the editor

The board is running real firmware right now. Click it to open the circuit in the editor.

The model

## What is modeled

Taken from the board's own contract document and put in plain words, with what is missing beside it.

### Modeled

Core

One Xtensa LX7 core, the ESP32-S3 DevKitC-1 model whole

Flash

1,310,720 bytes for the sketch, as the Arduino IDE’s default partition gives it

GPIO

Every pin on the headers, numbered as the silkscreen numbers it

The user LED

GPIO 48, lit when the pin is HIGH, as LED_BUILTIN

UART0

TX and RX, wired to the serial monitor

WiFi, simulated

WiFi.h over a network written in software: no radio, no 802.11, and real internet only when you sign in and switch it on

### Not modeled

- The OV2640 camera: its pins are ordinary GPIOs here and no image comes from it. esp_camera_init() returns ESP_ERR_NOT_FOUND and says why.
- The 8 MB of PSRAM, and the microSD slot.
- The second core, USB, I2S and the radio’s Bluetooth.

Start here

## Open one and press Run

Each of these opens in the editor exactly as it is drawn here.

## Questions

Is it free?

Yes. Every board and every part is on the free plan, with no account needed.

Does the camera work?

No. The camera is drawn, but nothing simulates it, so esp_camera and its image never arrive; init fails with a message that says so. Everything else on the board does run.

Is it the same as the ESP32-S3 DevKitC-1?

Same chip, same firmware and the same header, on a camera board with PSRAM.

Also here

## The other boards

Every one of these runs today, and every one is free.

ESP32-C3-DevKitM-1

A RISC-V chip at 160 MHz, on the real memory map.

Open the board page

Arduino Uno R3

The classic Arduino, with an ATmega328P running at 16 MHz.

Open the board page

Arduino Nano

The Uno’s chip on a small board that fits a breadboard.

Open the board page

Arduino Mega 2560

The big Arduino, with 54 digital pins and four serial ports.

Open the board page

Arduino Leonardo

An Uno-shaped board whose chip does its own USB serial.

Open the board page

ESP32-C6-DevKitC-1

A second RISC-V board, with 31 pins and simulated WiFi.

Open the board page

ESP32 DevKit V1

The classic ESP32 at 240 MHz, with simulated WiFi.

Open the board page

ESP32-S3-DevKitC-1

The ESP32-S3 at 240 MHz, with USB serial and an RGB LED.

Open the board page

All 42 boards

## Try it on your own firmware

What you build here runs on the board on your desk, unchanged. Nothing to install and no account needed.

Start building free Open the editor
